Power Connection; Connecting The Lcd Tv To A Pc; Connecting To A Dvd Player; Using Side Av Connectors - Salora LCD2631DVX Mode D'emploi

Power Connection

IMPORTANT : The TV set is designed to operate on
220-240V AC, 50 Hz.
• After unpacking, allow the TV set to reach the
ambient room temperature before you connect the
set to the mains.
• Plug the power cable to the mains socket outlet.

Connecting the LCD TV to a PC

For displaying your computer's screen image on
your LCD TV, you can connect your computer to the
TV set.
• Power off both computer and display before making
any connections.
• Use 15-pin D-sub display cable to connect a PC to
the LCD TV.
• When the connection is made, switch to PC source.
See "Input selection" section.
• Set the resolution that suits your viewing requirements.
Resolution information can be found in the appendix
parts.

Connecting to a DVD Player

If you want to connect a DVD player to your LCD
TV, you can use connectors of the TV set. DVD
players may have different connectors. Please refer
to your DVD player's instruction book for additional
information. Power off both the TV and the device
before making any connections.
Note: Cables shown in the illustration are not
supplied.
• If your DVD player has an HDMI socket, you can
connect via HDMI. When you connect to DVD player
as illustrated below, switch to HDMI source. See,
"Input Selection" section.
• Most DVD players are connected through
COMPONENT SOCKETS. Use a component video
cable to connect video input. For enabling audio,
use a component audio cable as illustrated below.
03_MB25_[GB]_(01-TV)_COST_1900UK_IDTV_BRONZE9_26883W_10064216.indd 84 03_MB25_[GB]_(01-TV)_COST_1900UK_IDTV_BRONZE9_26883W_10064216.indd 84
When the connection is made, switch to YPbPr
source. See, "Input selection" section.
• You may also connect through the SCART socket.
Use a SCART cable as shown below.
Note : These three methods of connection perform the
same function but in different levels of quality. It is not
necessary to connect by all three methods.

Using Side AV Connectors

You can connect a range of optional equipment
to your LCD TV. Possible connections are shown
below. Note that cables shown in the illustration are
not supplied.
• For connecting a camcorder, connect to the VIDEO
IN socket and the AUDIO SOCKETS. Do not connect
the camcoder to VIDEO IN socket at the same time
since it can cause noise in the picture. For selecting
the related source, see the section "Input selection"
in the following parts.
• To listen the TV sound from headphones, connect
to the HEADPHONE jack of theTV.
English - 84 -
31.08.2009 13:16:42 31.08.2009 13:16:42