Power Supply; General Functions - Salora Elite 1 Manuel D'utilisation

POWER SUPPLY

Mains operation
Check if the mains voltage on the type plate (on the bottom of the device) corresponds to your local
mains supply. If not, consult your dealer or service organization.
1. Insert the power cord into the AC Input socket on the side of the device.
2. Plug the mains plug into the mains socket.
Caution:
In order to disconnect the device from the mains completely, the mains plug should be removed from the
mains socket completely.
Battery operation (Remote Control)
1. Open the battery compartment at the back of the remote control by pulling out the cover..
2. Insert two batteries (2 x 1.5V, Type R03 / UM4 / AAA size) with the correct polarity as shown in the
battery compartment.
3. Replace the cover.
4. If the remote is not to be used for any extended period of time, it is recommended that the batteries
are removed.
Caution:
Do not expose the batteries to excessive heat such as sunshine, fire or the like.
Remove the batteries from the device when they will not be used for a long period of time.
Notes:
Batteries should not be disposed of by incineration and with household waste. Disposable batteries
should be taken to a suitable recycling centre if possible.
All manuals and user guides at all-guides.com
7

GENERAL FUNCTIONS

Switching the device on and off
1. Press the On/Off button to switch on the device from standby mode. The last function used is
automatically selected.
2. Switch the device to standby by pressing the On/Off button. The display shows "GOOD BYE"
Adjusting the brightness of the display
1. Press the Dimmer button to adjust the brightness of display backlight in three levels (bright,
medium, or off).
2. The auto dimmer function automatically adjusts the intensity of display backlight to suit the
brightness of the surroundings.
Notes:
Minimum power consumption in standby mode is only achieved if the display backlight is switched off.
Changing the color of display
1. Repeatedly press the Color button to change the color of display backlight. There are 8 colors for
selection.
Selecting the function mode
1. Repeatedly press the Function button to select the function between FM Tuner, MW Tuner, CD, SD
and Auxiliary input modes.
Adjusting the volume
1. Adjusts the volume by pressing the Volume− or Volume+ button.
Muting
1. Pressing the Mute button to switch the sound on and off. The display shows "Mute".
Switching the Ultra Bass System on and off
This function boosts the bass frequencies.
1. Press and hold the DSC/UBS button to switch the Ultra Bass System on and off. The display shows
the symbol when UBS is switched on.
Notes:
Listening with UBS at high volume may have distortion. Recommend to use at low volume.
Selecting the sound effects
You can select the sound settings USER, CLASSIC, POP, JAZZ and ROCK. The default setting is USER.
1. Repeatedly press the DSC/UBS button to select the desired sound setting. Symbol is shown on the
display to indicate your setting.
8