Fulgor Milano Sofia 30 DUAL FUEL Guide D'utilisation Et D'entretien page 50

32 - Solving Operational Problems
EN
Oven Problem
Surface burner flames are uneven yellow and/or noisy
Are the burner ports clogged?
Are the burner caps positioned
properly?
Is propane gas being used?
Surface burner makes clicking noises
Is the burner wet?
Is the cap and gas spreader
positioned correctly?
Is the cooking vessel much larger
than the allocated grate space?
Excessive heat around cookware on cooktop
Is the cookware the proper size?
Cooktop cooking results not what expected
Is the proper cookware being
used?
Is the control knob set to the proper
heat level?
46
Problem Solving Steps
See "Super Sealed Surface Burners" section.
See "Super Sealed Surface Burners" section.
The appliance may have been converted improperly. Contact a service technician.
Let it dry.
Make sure the alignment pins are properly aligned see "Super Sealed Surface Burners"
section.
Remove vessel temporarily, if clicking ceases and then returns when putting the vessel back,
it is due to the oversized vessel. You can still continue to cook with the vessel but the clicking
will continue until cooking is complete.
Use cookware about the same size as the surface cooking area, element or surface burner.
Cookware should not extend more than 1 in (2.5 cm) outside the cooking area.
See "Cookware" section.
See "Setting the Control Knobs" section.