Adjusting The Display Contrast; Dimmer Control - Clarion DXZ435 Mode D'emploi

Operations Common to Each Mode
5. Press the [DISP] button to select a character.
Each time you press the [DISP] button, the
character changes in the following orders:
Numbers ➜ Symbols ➜ Capital letters ➜
Numbers...
6. Turn the [ROTARY] knob to select the
desired character.
7. Repeat step 4 to 6 to enter up to 30
characters for message.
8. Press and hold the [
seconds or longer to store the message in
memory and cancel input message.
9. Press the [TITLE] button to return to the
previous mode.
Setting the method for title scroll
Set how to scroll in CD-TEXT or MD.
∗ The factory default setting is "ON".
1. Press and hold the [TITLE] button for 1
second or longer to switch to the adjustment
selection display.
2. Press the [a] or [d] button to select
"SCROLL".
3. Turn the [ROTARY] knob clockwise or
counterclockwise and select "ON" or "OFF".
G ON:
To scroll automatically.
G OFF:
To scroll just 1 time when the title was
changed or the title key was pressed.
4. Press the [TITLE] button to return to the
previous mode.

Dimmer control

You can set the dimmer control on or off.
∗ The factory default setting is "ON".
1. Press and hold the [TITLE] button for 1
second or longer to switch to the adjustment
selection display.
2. Press the [a] or [d] button to select
"DIMMER".
3. Turn the [ROTARY] knob clockwise to "ON"
or counterclockwise to "OFF".
4. Press the [TITLE] button to return to the
previous mode.
18
DXZ435
] button for 2

Adjusting the display contrast

You can adjust the display contrast to match the
angle of installation of the unit.
∗ The factory default setting is "5". (Adjustment
level:1to 8)
1. Press and hold the [TITLE] button for 1
second or longer to switch to the adjustment
selection display.
2. Press the [a] or [d] button to select
"CONTRAST".
3. Turn the [ROTARY] knob clockwise or
counterclockwise to adjust the contrast.
4. Press the [TITLE] button to return to the
previous mode.
Setting LOW PASS FILTER
This function allows you to set the low-pass filter
sub-woofer output.
∗ The factory default setting is "LPF 120".
1. Press and hold the [TITLE] button for 1
second or longer to switch to the adjustment
selection display.
2. Press the [a] or [d] button to select "SW
LPF".
3. Turn the [ROTARY] knob clockwise or
counterclockwise to select the setting. Each
time you turn the [ROTARY] knob, the setting
changes in the following order:
REAR ➜ LPF 50 ➜ LPF 80 ➜ LPF 120
4. Press the [TITLE] button to return to the
previous mode.
Selecting AUX IN sensitivity
Make the following settings to select the
sensitivity when sounds from external devices
connected to this unit are difficult to hear even
after adjusting the volume.
∗ The factory default setting is "MID".
1. Press and hold the [TITLE] button for 1
second or longer to switch to the adjustment
selection display.
2. Press the [a] or [d] button to select "AUX
SENS".
3. Turn the [ROTARY] knob clockwise or
counterclockwise as needed and select from
"HIGH", "MID" or "LOW".
4. Press the [TITLE] button to return to the
previous mode.