Speedlink RF CubePad Mode D'emploi page 13

Always recycle or dispose of used batteries in
accordance with local regulations.
If a battery leaks, remove all batteries and
thoroughly clean the battery compartment
with a damp paper towel, or follow the battery
manufacturer`s recommendations for clean-up.
5 Installation
1. Turn off your Game Cube.
2. Connect the receiver to the controller port 1
of your Game Cube.
3. If using only one controller, channel 1 must
be selected on your gamepad and your
receiver. If using more than one controller
please refer to chapter 5
6 Channel and band settings
Note: To guarantee a correct operation of your
controller, please make sure that if using only
one controller the band and channel settings are
selected as indicated in the table below.
All manuals and user guides at all-guides.com
D
GB
F
E
I
13