Security+ ® 3-Button Remote Control; Programming; Programming (Optional) - LiftMaster ATS2113X 1/2 HP Manuel D'installation

PROGRAMMING

NOTICE:
If this Security +
of the door operator, which provides security against code-theft devices, will be circumvented. The owner of the copyright in
the door operator does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that technical
measure.
Security +
The 300 Series remote control works only with door
operators and light controls having a purple "LEARN" button.
A maximum of eight remote control push buttons may be
programmed.
Programming instructions are described and illustrated below.
The additional push buttons can also activate other door
operators and/or light controls. (Instructions for programming
light products are included with those accessories.)
Instructions are Described and Illustrated Below
1. Press and release the "LEARN"
button on the motor unit. The
LEARN indicator light will glow
steadily for 30 seconds.
2. Within 30 seconds, press and
hold the button on the hand-held
remote.
3. Release the button when the motor
unit light blinks. It has learned
the code. If light bulbs are not
installed, two clicks will be heard.
To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, fi rst erase all codes:
Press and the hold "LEARN" button on motor unit until the
learn indicator light goes out (approximately 6 seconds). All
previous codes are now erased. Reprogram each remote or
keyless entry you wish to use.
®
door operator is operated with a non-rolling code transmitter, the technical measure in the receiver
®
3-Button Remote Control Programming (Optional)
To prevent possible SERIOUS INJURY or DEATH from
a moving door:
• ALWAYS keep remote controls out of reach of
children. NEVER permit children to operate, or play
with remote control transmitters.
• Activate door ONLY when it can be seen clearly, is
properly adjusted, and there are no obstructions to
door travel.
• ALWAYS keep door in sight until completely closed.
NEVER permit anyone to cross path of moving door.
To Control the Operator Lights
®
With Security+ remote controls, a remote push button can
be programmed to operate the operator lights without opening
the door.
1. With the door closed, press and hold the remote button
that you want to control the light.
2. Press and hold the Light button on the door control.
3. Press and hold the Lock button on the door control.
4. After the operator lights fl ash, release all buttons.
Test by pressing the remote push button. The operator lights
should turn on or off but the door should not move.
Open/Close/Stop Operation
NOTE: Requires optional 78LM (or similar) Multi-Function
Door Control Panel with Lock button to program
Open/Close/Stop operation. Refer to accessories.
®
Your Security+ remote control can be programmed to
operate one door using all 3 buttons:
the large button will only open the
door, the middle button will close the
door and third button will stop the
door's movement. You may set up
this feature as follows:
1. With the door closed, press and hold the large remote push
button.
2. Press and hold the Lock button on the door control.
3. Press and hold the door control push bar.
When the operator lights fl ash, release all buttons. Test by
pressing the large (Open) button on the remote. The door
should open. Press it again while the door is open and nothing
should happen. Press the middle (Close) button and the door
should close. Press the third (Stop) button while the door is
moving and it should stop immediately.
29
Open
Close
Stop