Changing The Water Filter - AEG ARE5047XB Mode D'emploi

Step 15.
Switch ON Ice Maker. (except model ARE5047.)
Refer to Controlling section
Once the refrigerator has been running for at least 24 hours
remove the ice bin and dispose of the first few batches of ice
to ensure that impurities have been flushed from the system.
Party Ice (except model AFE4227)
When the Ice Bin is removed from the cabinet the Auto Ice
Maker will continue to dispense ice into the top freezer
drawer.
CAUTION
Water dispenser should not be used for extended periods
of time. After 2 minutes of continuous use the water
dispenser will automatically shut off.

CHANGING THE WATER FILTER

IMPORTANT
• Always fit the filter as per
manufacturer's instructions.
•
If you need to replace water tube, only use approved
water quality piping that meets the pressure
requirements.
• Make sure your refrigerator is level to avoid uneven
ice cubes.
• Replace filter at suggested intervals to avoid water/
ice reduction and irregularities in taste.
• Remove and clean ice bin once a month, discarding
unused ice cubes. This will ensure fresh, clean ice
and smooth operation of your ice maker.
• Clean and empty the dispenser drip tray regularly to
avoid overflow.
WARNING
• Use the appliance with water filter supplied by
Electrolux Home Products Pty Ltd or its authorized
service agent only.
• For correct operation of this appliance it is essential
to observe the manufacturer's instructions
Internal Water filter
The water filter is located at the top left side of the fresh
food compartment.
All manuals and user guides at all-guides.com
Replacing the water filter
You should change the water filter every six months to
ensure the highest possible water quality.
If your refrigerator has not been used for a period of
time (during a house move for example), change the
filter before reinstalling the refrigerator.
It is not necessary to turn the water supply off to change
the filter. Be ready to wipe up any small amounts of water
released during the filter replacement.
1. Ensure that the ice maker
is turned off
(Diagram 1).
2. Remove the filter by
turning anti-clockwise
180˚.
3. Slide the old water filter
cartridge straight out of the
housing and discard it.
(Diagram 2).
4. Unwrap the new filter
cartridge and using the
alignment guide, slide it
gently into filter housing
until it stops against the
filter connection at the
back of the housing.
(Diagram 3).
5. Engage the filter by firmly
rotating clockwise until the
filter snaps into position
(once engaged the filter
cannot be rotated further).
(Diagram 4).
6. Press a drinking glass
against the water
dispenser while checking
for any leaks at the filter
housing. Any spurts and
sputters that occur as the
system purges air out of
the dispenser system are
normal.
7. After filling one glass of
water, continue flushing
the system for about four
minutes.
8. Turn on the ice maker.
(Diagram 5).
9. When the filter has been
replaced press and hold
the 'Ice and Water' button
for three seconds to reset
the filter replace timer.
English 13
D D i i a a g g r r a a m m 1
D D i i a a g g r r a a m m 2
D D i i a a g g r r a a m m 3
D D i i a a g g r r a a m m 4
D D i i a a g g r r a a m m 5