Important; Internal Filter - AEG ARE5047XB Mode D'emploi

Contents of installation kits
Filter Kit for single door freezer
1 x water filter with push fit connections
DATE FITTED___/___/___
2 x mounting brackets and screws
4 + 1 metres of water tubing
1 x 1/2" tap fitting
2 x circlips
Water supply and plumbing
A drinkable water supply to suit a 1/2" tap fitting is
required adjacent to the refrigerator. It is recommended
that a licensed plumber install a new water supply outlet
nearer to the appliance should the tubing supplied not be
long enough. It is not recommended that the tubing be
extended as this could adversely affect the flow of water to
the ice maker or water dispenser. If there is a risk of flow
rate higher than the maximum flow rate 2.46 L/min, a flow
controller should be installed.
The water dispenser and automatic ice maker require a
drinkable water supply with a pressure range of between
206kPa and 689kPa (30PSI and 100PSI).
If the water supply is above 100psi a pressure limiting
valve should be installed.
It is recommended that a noise reduction valve also be
fitted in the water supply line. This will reduce water
hammer and its effects from quick action household taps
and fast acting valves on appliances.
The refrigerator water valve is pre-fitted with a push-fit
connector for inserting the water tube. When the tap
connection is other than 1/2", adapters can be purchased
from plumbing supply stores or good hardware stores.
INSTALLATION
Please read before beginning installation.
The appliance complies with the relevant backflow
prevention requirements specified in AS/NZS 2845.1.
The water connection to your ice and water product can
be self installed. However, it is recommended that you
seek advice from a licensed plumber before commencing
the installation.
All manuals and user guides at all-guides.com
Installation Kit
Bottom mount & single
door all refrigerator
4 metres of water tubing
1 x 1/2" tap fitting

IMPORTANT

Check for water leaks at all water connection points in the
first 2 to 3 hours after installation, and correct it in case of
any water leak. Recheck after 24 hours; if a leak still
occurs, it is recommended to contact a licensed plumber
for advice.
Water is to be connected as per diagrams below.

Internal Filter

Single door freezer with external filter
sink
brackets
mains
water inlet
kitchen
cupboard
Step 1.
Ensure that the refrigerator
is disconnected from power
supply.
Step 2.
Connect tap fitting to water
supply tap. Tap must be close
to the refrigerator.
Step 3.
Push the tube into tap fitting
past insertion mark.
English 11