AEG ARE5047XB Mode D'emploi page 12

12 www.aeg.com
(NOTE: step 4 to step 10 relate to models with an
external filter only).
Step 4.
Install brackets for filter
close to tap. Plan to leave
as much tubing as possible
behind the refrigerator to
enable it to be moved easily
for cleaning or service.
Do not screw the brackets
into the refrigerator as this
may void your warranty and
permanently damage the
refrigerator.
Step 5.
Write date on filter. The filter
will need to be replaced every
6 months.
Step 6.
Extend the collar and clip a
circlip around the collar at
both ends of the filter.
Step 7.
Fit the filter to brackets with
water flow arrow pointing up.
Step 8.
Push shorter tube into tap
fitting past insertion mark.
Step 9.
Push other end into filter
INLET.
Step 10.
Connect remaining tube
length into filter OUTLET.
Water filter contains carbon
dust which is non-toxic.
Using a large container, turn
on water and purge the
residual carbon dust from
filter until water runs clear.
All manuals and user guides at all-guides.com
Step 11.
Connect other end of remaining tube length to inlet on
bottom right hand side of refrigerator.
Step 12.
Turn on water and check all
joints and tubes for leaks.
Step 13.
Reconnect the power.
Step 14.
Switch On Water Dispenser
(except model AFE4227.)
Using a large container, run the water dispenser to clear
air from lines. This may take a few minutes. Purge and
dispense a minimum of 2 litres of water. Initial water may
be black in colour. This is residual carbon dust from the
filter and is non-toxic. If the water is slow to shut off or the
dispenser is dripping, air may still be in the lines. Either
purge more water through the system to remove this air
or allow some time for the air to be removed over
subsequent dispensing.
For normal use, water dispenser will automatically shut off
after 2 minutes of continuous operation.
IMPORTANT
As the water cut off is not instant, leave the glass under
the dispenser briefly until the water has stopped flowing to
avoid spills.
Clean and empty the dispenser drip tray regularly to avoid
overflow.
Flushing system about 2 minutes after period of non-use
exceeding 30 days