Fitting The Handles; Water Filter - AEG ARE5047XB Mode D'emploi

10 www.aeg.com
4. Check the alignment of the refrigerator to the
surrounding cupboards to see if it is level. You can
adjust the level as detailed in step 2 and 3.
aligned to
cupboards
ie even gap.
5. I f you find your refrigerator rocks from corner to
corner, it means your floor is uneven. Find a piece of
plastic or hardboard etc. and pack it firmly under the
roller.
6. You may now need to fine-tune the installation by
repeating steps 3, 4 and 5.
7. When you have the appliance in its final position, it
needs to be stabilised. Wind the stability foot under
the door hinge down to the floor until it just makes
contact with the floor. Lift the front of the appliance to
take the weight off the stability foot, then turn it half a
turn further to ensure firm contact with the floor.
Wind the large height adjusting nut back up to ensure
all the weight is now on the front stability foot.
8. Repeat step 7 for the stability foot on the handle side.
Whenever you need to move the appliance, be sure
to wind the feet back up so that the appliance can roll
freely and be sure to reset it when reinstalling.
Large height
adjusting nut
wound up.
9. Plug your refrigerator straight into its own power
point and never use a double adapter. If you need
to roll the refrigerator to get to the plug, remember
to raise the stability foot first.
10. Before you put any food in your refrigerator, it's
recommended you leave it on for 2 or 3 hours to
check it is running properly.
All manuals and user guides at all-guides.com
top of refrigerator
is level ie
horizontal.
adjust front feet for
uneveness of floor
eg. wind this foot
down or up.
stability foot
wound down

FITTING THE HANDLES

For models with 'Pole' handles, the handles are supplied
prepackaged with your refrigerator and will require fitting.
Refer to the instructions provided in the pack.
Congratulations! You have successfully installed your new
refrigerator.
ICE AND WATER MODELS
WARNING
Connect to potable water supply only, if using tank or bore
water in a model with an internal filter it is recommended
to also use an external filter
(not supplied).
The new hose sets supplied with the appliances must be
used and old hose sets should not
be reused.
Never connect the appliance to a hot water supply.

WATER FILTER

Do not use with water that is microbiologically unsafe or
with water of unknown quality without adequate
disinfection. The service life of the filter may be reduced in
water supplies that contain an excess of particles or other
impurities. Reduced flow rate is an indication that a new
filter is required. Failure to replace the filter when required
can affect the function of the ice maker. Service calls
caused by a failure to replace the filter are not covered by
warranty. Replacement water filters are available from
Electrolux Home Products Spare Parts Centres and can be
posted to you for your convenience (refer to spare parts
contact numbers on the warranty page).