Installing Your New Appliance - AEG ARE5047XB Mode D'emploi

INSTALLING YOUR NEW APPLIANCE

UNPACKING
ENVIRONMENT
Most of the packing materials are recyclable. Please
dispose of those materials through your local recycling
depot or by placing them in appropriate collection
containers.
Important – check for any damages or marks. If you find
the refrigerator is damaged or marked, you must report it
within 7 days should you wish to claim for damage/ marks
under the manufacturers warranty. This does not affect
your statutory rights.
Clean your refrigerator thoroughly following the instructions
in the "Cleaning" section and wipe off any dust that has
accumulated during shipping.
LOCATING THE REFRIGERATOR
CAUTION
Automatic aerosol systems (such as insect control) should
not be located adjacent to the product as the spray may
cause long term damage to the external surfaces of the
appliance.
Do not put the refrigerator in a location that is too cold or is
unprotected, for example in a garage or on a veranda. The
ambient temperature should be above 10°C.
Put the refrigerator in a dry place avoiding areas of high
moisture or humidity.
Ensure the refrigerator is located on an even surface.
Adequate ventilation around your refrigerator
The diagram below shows the recommended airspace to
allow for ventilation of your refrigerator.
50mm
X
Recommended
airspace
CABINET
DOOR
If you have a cupboard above the
refrigerator with a rear gap of less than
100 mm (Y), recommended clearance at
the top of the refrigerator increases from
30mm to 70mm (X) minimum.
All manuals and user guides at all-guides.com
Y
When positioned in a corner area, spacing of at least
350mm on the hinge side will allow the doors to open
enough to enable the removal of bins and shelves.
NOTE: Doors are designed to sit proud of cabinetry
(not flush). The clearances shown above are the
recommended minimum clearances.
The clearance at the rear must not exceed 75mm.
INSTALLING YOUR REFRIGERATOR
1. Roll the refrigerator into place.
Height
adjusting
nut
The rollers are designed for forward or backward
movement only. They are not castors. Moving the
refrigerator sideways may damage your floor and the
rollers. Before moving your refrigerator ensure height
adjusting nut and the stability foot are fully wound up
off the floor.
2. Wind the large height adjusting nut under door hinge
down until the refrigerator is tilted back by 10mm
(see diagram).
3. Wind the large height adjusting nut on the handle
side down until the refrigerator is level and stable. If
you have difficulty winding the nut or height adjusting
foot down, have someone tilt the refrigerator back so
you have better access.
English 9
10 - 15mm
Fixed rear rollers
stability foot
wound up