Scope Of Delivery; Intended Use - Scheppach dp13 Traduction Du Manuel D'origine

1. Introduction
Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope you have a lot of fun and success using your
new machine.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability for
damages to the product or damages caused by the prod-
uct that occurs due to:
• improper handling,
• noncompliance of the operating instructions,
• repairs by third parties, not by authorized service
technicians,
• installation and replacement of non-original spare
parts,
• non-intended use,
• A breakdown of the electrical system that occurs due
to the non-compliance of the electric regulations and
VDE regulations 0100, DIN 57113 / VDE0113.
We recommend:
that you read through the entire operating instructions
before putting the machine into operation.
These operating instructions are to assist you in getting
to know your machine and utilize its proper applications.
The operating instructions contain important notes on
how you work with the machine safely, expertly, and
economically, and how you can avoid hazards, save re-
pair costs, reduce downtime and increase the reliability
and service life of the machine. In addition to the safety
requirements contained in these operating instructions,
you must be careful to observe your country's applicable
regulations.
The operating instructions must always be near the ma-
chine. Put them in a plastic folder to protect them from
dirt and humidity. They must be read by every operator
before beginning work and observed conscientiously.
Only persons who have been trained in the use of the
machine and have been informed of the various dangers
may work with the machine. The required minimum age
must be observed. In addition to the safety requirements
in these operating instructions and your country's ap-
plicable regulations, you should observe the generally
recognized technical rules concerning the operation of
identically constructed devices.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
2. Device description (Fig. 1-2)
1 Base plate
2 Pillar
3 Drilling table
4 Machine head
5
Keyless drill chuck
6 Grips
7 Drill chuck protection
8 Depth stop
9 Motor
10 On-Off switch
11 Belt protective hood
12 Locking grip for belt tension

3. Scope of delivery

Base plate (1)
Pillar (1)
Drilling table (1)
Machine head (1)
Keyless drill chuck(1)
Grips (3)
Chuck protection (1)
Fastening screws (3)
Allen key (hexagon socket screw key) 4mm (1)
Operating manual (1)
• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the
packaging and transport bracing (if available).
•
Check that the delivery is complete.
• Check the device and accessory parts for trans-
port damage.
• If possible, store the packaging until the warranty
period has expired.
m Attention!
The device and packaging materials are not toys!
Children must not be allowed to play with plastic bags,
film and small parts! There is a risk of swallowing and
suffocation!

4. Intended use

This pillar drill is designed for drilling metal, plastic,
wood and similar materials. It is intended for use in the
private sector only.
Food and harmful materials may not be processed with
the equipment. The drill chuck is only designed for use
with drill bits and tools with a shaft diameter of 1.5 to 13
mm, and for cylindrical tool shanks. The equipment is
intended for use by adults only.
The equipment is allowed to be used only for its pre-
scribed purpose. Any other use is deemed to be a case
of misuse. The user/operator and not the manufacturer
will be liable for any damage or injuries of any kind
resulting from such misuse.
GB
19 / 132