Installing The Drip Tray; Cooking Modes - Cuisinart GRIDDLER PRO GR50E Instructions

• BARBECUE POSITION
Insert the Grill cooking plates then open the cooking surface to
the flat position by pulling on the button located on the right
of the handle . Select the cooking mode (see section 3E) . After
preheating, place the food on the plates .
• SALAMANDER POSITION (GRILLING WITHOUT CONTACT)
Insert the cooking plates of your choice into the appliance . Select
the cooking mode (see section 3E) . After preheating, place the
food on the lower plate then gently close the lid . Then manually
adjust the distance between the upper plate and the food by
sliding the latch on the floating hinge to the notch of your choice .
D. Installing the drip tray
At the back of the appliance base there is slot for the drip tray .
• Slide the drip tray from right to left into this slot (Fig . 3) .
Fig . 3
17_GR50E_IB_RC.indd 21
• The fats and juices from cooking the foods flow over the plates
and are collected in the drip tray .
• Empty the drip tray after the Griddler Pro has cooled completely .
• The drip tray can be washed in the dishwasher .
E. Cooking modes
The Griddler Pro lets you control the cooking temperature
manually or to select from preprogrammed temperatures . These
cooking modes can be selected using the middle control on your
grill .
Note: Never put food on the plates while the appliance is
preheating, whatever the chosen mode (Manual, Minimum or
Maximum) .
MANUAL MODE "M"
This mode activates the 2 temperature controls . It lets you choose
the temperatures for each of the plates to adjust as accurately
as possible to the type of food being cooked . It's also ideal for
cooking in the flat position because it lets you cook different
kinds of food on each plate .
• Once the plates are in place, plug the unit into an electrical
outlet then turn the middle control to "Manual" . The indicator
light for the middle control will turn red and the temperature
controls will start flashing red .
• Turn the left and right controls to select the temperature for
each of the plates .
• Close the lid of your grill to allow it to preheat .
• When the appliance has reached the selected temperatures,
indicator lights will stop blinking and the red light will stay lit .
• Select the cooking position (see section 3C) then place the food
on the plates .
Note: When cold food is placed on the grill, the temperature of
the plates may temporarily drop below the selected temperature .
When this happens, the indicator lights for the temperature
controls will start flashing red . The blinking will go out when
temperature of each plate is set
• You can then change the temperature of each of the plates
during cooking if necessary .
the
the
21
29/05/17 08:29