Disposal And Recycling - Scheppach 7906100719 Notice Originale

• Check the speed and vibration levels after each use.
• Check the idle speed regularly and after any mainte-
nance is performed: use a rev counter and perform
the measurement without any clamped tools. The
idle speed may not be exceeded under any circum-
stances at a residual pressure of 6.3 bar.
• If the appliance is exhibiting excessive vibration le-
vels, the cause of the vibrations must be identified
and repaired.
• Use only the genuine replacement parts recommen-
ded by the manufacturer, otherwise you could put
users at danger. In doubt, contact the Service Cen-
tre.
• Check the grinding disc (9) regularly for damage.
• Clean the appliance with a soft, dry cloth only.
• Never use sharp or scratchy cleaning agents under
any circumstances.

Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types of
material, such as metal and plastic. Defective compo-
nents must be disposed of as special waste. Ask your
dealer or your local council.
Troubleshooting
Malfunction
Speed too slow, air escapes from the
outlet.
Appliance does not move; compressed
air escapes completely through the
outlet.
14 І 68
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Possible cause
Motor parts jamming due to dirt.
Pressure supply too low.
Motor is jammed due to material build-
up.
Remedy
Check the pressure supply filter for
contamination.
Check the pressure supply filter for
contamination.
Lubricate appliance as described in the
instructions.
If necessary, repeat the steps outlined
above.
Lubricate appliance as described in the
instructions.