Electrolux ASB8000 Mode D'emploi page 31

All manuals and user guides at all-guides.com
822 949 412_ASB8000.book Seite 31 Donnerstag, 29. Mai 2008 8:18 08
used incorrectly, no liability can be
accepted for any damage that may
be caused.
Child Safety
• Do not leave the appliance running
while unattended, or let children
near the appliance unsupervised!
• Children should be supervised to
ensure that they do not play with
the appliance.
• Packaging material, e.g. plastic
bags, should not be accessible to
children.
When operating the
appliance
• Always place the unit on a flat,
level surface.
• Never operate the appliance with
wet hands.
• Ensure the Speed Selector is in the
off position before plugging into
the power outlet.
• Plastic parts should never be dried
at or near direct sources of heat.
• The appliance must not be used
for mixing dyes (paints, or lacquer,
etc,). This can cause explosions!
• When you have finished using the
appliance, before cleaning, switch
off and pull the plug out of the
socket.
• The blade assembly should only
be disassembled by an authorised
technician.
• Never clean the motor casing
under running water or soapy
water.
• Caution! The blade assembly is
very sharp. Be careful when taking
the blender apart and re-assembling. It
may cause injury if handled
incorrectly.
• Do not leave hard objects (for
example spoons) in the blade
assembly while running, and do
not grasp the appliance with the
hand inside the blender tank. This
may cause injury!
Possible applications
The blender can be used for mix-
ing a wide variety of drinks, crush-
ing ice, reducing fruit and
vegetables, whipping cream, etc.
Cord storage
The appliance is fitted with a cord
storage facility at the bottom. If the
connection cord to the power out-
let is too long, it can be wraped
around the cord storage until it is
the required length.
Disassembling the Appliance
0 Take the plug out of the socket.
0 Remove the lid (Fig. 1/B).
0 Remove the blender tank
(Fig. 1/C).
0 Turn the blender blender tank
upside down.
0 Turn the blade assembly counter-
clockwise using the filler cup
(Fig. 1/A) as tool and remove
(Fig. 3). The grooves of the filler
cup fit the ribs of the blade assem-
bly.
0 You can now remove the rubber
seal (Fig. 4).
Caution! The blade assembly is
1
very sharp. It can cause injury if
handled incorrectly! The rubber
seal can easily be irreparably
damaged by the blade assembly.
Caution! Do not use force when
taking the blade assembly out of
the blender, as this might cause
damage. If necessary, tilt it slightly
when removing.
Do not attempt to remove the
stainless steel blades from the
blade assembly.
Assembling the Blender
0 Place the rubber seal on the blade
assembly.
g
31