GYS TIG 168 DC HF Mode D'emploi page 14

REMOTE CONTROL (TIG 200 only)
The remote control operates in TIG and MMA mode.
Connector technology
The TIG 200 is equipped with a female socket for a remote control. The specific 7 point male plug (GYS product
ref.045699) enables connection to a manual remote control (RC) or foot pedal (PEd).
For the cabling lay out, see the diagram below.
Ref.045699
Connecting remote/pedal
1- Power up the machine
2- Plug the pedal/remote control to the connecting socket on the machine.
3- The screen will flash and display « No » (Nothing),
4- Select the type of control by turning the intensity adjustment knob:
« No » (Nothing) / « RC »  (Remote Control) / « PEd »  (Pedal)
5- Turn the knob until the desired selecton is reached, and after 2 seconds the display will freeze on the chosen
selection.
NB: In case of error, unplug the remote control, ( « No » will be displayed) and re-start the connection process.
Remark: You will be asked to specify the remote connected each time the machine is powered up.
Functions
Manual remote control: (
The remote control enables the variation of current from minimum intensity (DC : 10A / MMA : 10A) to an intensity
defined by the user.
In this configuration, all modes and functions of the machine are accessible and can be set.
Pedal (
GYS product ref.045682)
In all modes excluding « Spot » mode, the pedal control enables variation of the current from the minimum intensity
(DC : 10A / MMA : 10) to an intensity definied by the user.
,
In TIG mode the machine will only operate in two-stage welding (2T mode). The upslope and downslope are not
automatic, and are controlled by the User with the foot pedal.
In « Spot » mode, the pedal control replaces the torch trigger (the pedal position has no effect on the current).
MAINTENANCE / ADVICE
• Maintenance should only be carried out by a qualified person.
• Ensure the machine is unplugged, and that the ventilator inside has stopped before carrying out maintenance
work. (DANGER High Voltage and Currents).
• GYS recommends removing the steel cover 2 or 3 times a year to remove any excess dust. Take this opportunity
to have the electrical connections checked by a qualified person with an insulated tool.
• Regularly check the condition of the power supply cord. If damaged, it will need to be replaced by the
manufacturer, its' after sales service or a qualified person.
• Ensure the ventilation holes of the device are not blocked to allow adequate air circulation.
SAFETY
Arc w elding can be dangerous and can cause serious and even fatal injuries.
Protect yourself and others.
Ensure the follow ing safety precautions are taken:
Arc radiation
Rain, steam, damp
Electric shock
Falls
GYS product ref.045675)
:
Protect yourself with a helmet fitted with filters in compliance with EN169 or EN 379.
Use your welding unit in a clean/dry environment (pollution factor ≤ 3), on a flat surface,
and more than one meter from the welding work-piece. Do not use in rain or snow.
This device must only be used with an earthed power supply. Do not touch high voltage
parts. Check that the power supply is suitable for this unit.
Ensure the unit is placed in a stable position to prevent the machine from falling onto
people/objects.
D : Switch contact
C : Earth
B : Cursor
A : + 5V
Nb : The Potentiometer value must be 10 KΩ
14/56