Prepare Hood - Broan Elite E661 Serie Guide D'installation

2. PREPARE INSTALLATION
Cut-out the openings for
duct (A) and power cable
(B), in cabinet or wall,
according to the direction
of discharge chosen.
See figures at right.
NOTE: The duct opening
width (A) is 10½",
centered.

3. PREPARE HOOD

NOTE: The following illustrations represent the standard model. The
Low Speed model blower wheel is slightly different (smaller
wheel) but the installation steps remain the same.
3.1 Pull latch tabs and remove filters from the hood.
3.2 Remove both screws retaining each side panel and set aside.
3.3 Press on tabs and pull to disconnect light assemblies from electrical
harnesses.
Remove both panels and set aside.
3.4 Remove both transport bracket retaining screws. Discard the
transport bracket and one of its screw (set the second screw aside).
Do not reinstall the transport bracket.
(CONT'D)
H
ORIZONTAL DISCHARGE
C L
A
3½"
5¼" 5¼"
HD0407A
CAUTION
4¼''
HD0408A
3" 7/8"
B
1½" .
DIA
HD0107
HO0160
HO0157
HO0167
- 5 -
V
ERTICAL DISCHARGE
CABINET BOTTOM
A 1½''
7/8''
B
5¼'' 5¼''
C L
7/8''
S
CREW
L
OCATIONS
S
CREW
L
OCATIONS
T
RANSPORT
B
RACKET
2''
2¼''