Festo CP-FB11-E Manuel D'utilisation page 16

3 Configuration
Caution
The node contains electrostatically sensitive compo
nents. The node will be damaged if you touch the con
tact surfaces of the plug connectors or if you do not
observe the regulations for handling electrostatically
sensitive components.
Proceed as follows when configuring:
1. Switch off the power supply.
2. Open the switch cover.
3. Use the rotary/DIL switches to set the following
(see section 4):
4. Screw the switch cover tight again.
5. If the CP system is the first or last field bus slave, a
terminating resistor must be fitted (see section 2):
Warning
S Check the measures required for putting your system
into a safe status in the event of an EMERGENCY
STOP.
Further information can be found in manual
P.BE−CP−FB11−E−.. .
16
Station number
Field bus baud rate
If desired: set compatibility.
Festo CP−FB11−E 0503f English