Black & Decker BXPW1400E Mode D'emploi page 7

DO NOT RETURN THIS PRODUCT TO THE
STORE, first contact your local
BLACK+DECKER o ce or nearest
authorized service center.
SAVE THESE INSTRUCTIONS
The appliance you have purchased is a
technologically advanced product designed
by one of the leading manufacturers of high
pressure pumps. To obtain the best
performance from your unit, read this
booklet carefully and follow the instructions
each time you use it. We congratulate you
on your choice and wish you successful
operation.
GENERAL SAFETY RULES
SAFETY INSTRUCTIONS
General power tool safety warnings.
Warning! Read all safety warnings
and all instructions. Failure to follow
the warnings and instructions listed
below may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for
future reference. The term in all of the
warnings listed below refers to your mains
operated (corded) power tool or battery
operated (cordless) power tool.
1. Safety "Must Nots"
a. Explosion or poisoning hazard. Do not
use the appliance with inammable or
toxic liquids, or any products which are
not compatible with the correct
operation of the appliance.
b. Injury hazard. Do not direct the water jet
towards people or animals.
c. Electric shock hazard. Do not direct the
water jet towards the unit itself, electrical
parts or towards other electrical
equipment
d. Short circuit hazard. Do not use the
appliance outdoors in case of rain.
e. Injury hazard. This machine is not
intended for use by persons (including
children) with reduced physical, sensory
or mental capabilities, or lack of
experience and knowledge. Children
should be supervised to ensure that they
(Original instructions)
do not play with the appliance.
f. Electric shock hazard. Do not touch the
plug and/or socket with wet hands.
g. Electric shock and short circuit hazard.
Do not use the appliance if the electrical
cable is damaged.
h. Explosion hazard. Do not use the
appliance if the high pressure hose is
damaged.
i. Accident hazard. Do not jam the trigger
in the operating position.
j. Accident hazard. Check that the data
plates are axed to the appliance, if not,
inform your dealer. Units without plates
must not be used as they are unidentiable
and potentially dangerous.
k. Explosion hazard. Do not tamper with or
alter the calibration of the safety valve.
l. Hazardous alteration of operating
performance. Do not alter the original
diameter of the spray head nozzle.
m. Accident hazard. Do not leave the
appliance unattended.
n. Short circuit hazard. Do not move the
appliance by pulling on the electrical
cable.
o. Make sure that cars do not drive over the
high pressure hose.
2. Safety "Musts"
a. Short circuit hazard. All electrical
conductors must be protected against
the water jet.
b. Electric shock hazard. The appliance
must only be connected to an adequate
power supply in compliance with all
applicable regulations.
• Use of a safety residual current
circuit-breaker (R.C.C.B.) will provide
additional protection for the operator
(30mA).
c. Injury hazard. The high pressure may
cause materials to bounce of surfaces at
speed; therefore protective clothing and
safety goggles, safety boots, safety
gloves, safety helmets with visors,
hearing protection must be worn.
ENGLISH
7