Black & Decker BXPW1400E Mode D'emploi page 12

ENGLISH
Storage
1. Switch the appliance o (OFF/0).
2. Remove the plug from the socket.
3. Turn off the water supply tap.
4. Discharge the residual pressure from the
gun until all the water has come out of
the nozzle.
5. Drain and wash out the detergent tank at
the end of the working session. To wash
out the tank, use clean water instead of
the detergent.
6. Engage the gun safety catch (20).
Recommended cleaning
procedure
Dissolve dirt by applying the detergent
mixed with water to the surface while still
dry. When dealing with vertical surfaces
work from the bottom upwards. Leave the
detergent to act for 1-2 minute but do not
allow the surface to dry. Starting from the
bottom, use the high pressure jet at a
minimum distance of 30 cm. Do not allow
the rinse water to run onto unwashed
surfaces. In some cases, scrubbing with
brushes is needed to remove dirt. High
pressure is not always the best solution for
good cleaning results, since it may damage
some surfaces. The finest adjustable nozzle
jet setting or the rotating nozzle should not
be used on delicate or painted parts, or on
pressurised components (e.g. tyres, inflation
valves, etc.). E ective cleaning depends on
both the pressure and volume of the water
used, to the same degree.
MAINTENANCE (Fig. E)
Any maintenance operations not covered by
this chapter should be carried out by an
Authorized Sales and Service Centre.
¡Important! To ensure product
SAFETY and RELIABILITY, repairs,
maintenance and adjustment (other
than those listed in this manual) should be
performed by authorized service centers or
other qualified organizations, always using
identical replacement parts. Unit contains
no user service able parts inside.
12
(Original instructions)
appliance.
Cleaning the nozzle
1. Disconnect the lance from the nozzle.
2. Remove any dirt deposits from the nozzle
Cleaning the filter
Inspect the intake filter (7) and detergent
filter (if fitted) before each use, and clean in
accordance with the instructions if
necessary.
Unjamming the motor (On models
with this feature)
In case of lengthy stoppages, limescale
sediments may cause the motor to seize. To
unjam the motor, turn the drive shaft with a
tool.
End-of-season storage
Treat the appliance with non-corrosive,
non-toxic antifreeze and lubricate the
o-rings using the lubricating grease tube
(where supplied) as shown before storing it
away for winter. Put the appliance in a dry
place, protected from frost.
Protecting the environment
Should you find one day that your
BLACK+DECKER product needs
replacement, or if it is of no further use to
you, do not dispose of it with household
waste. Make this product available for
separate collection.
recycled materials helps prevent
environmental pollution and reduces the
demand for raw materials.
Local regulations may provide for separate
collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
Caution! Always disconnect the plug
from the power socket before
carrying out any work on the
hole using the tool (10).
Separate collection. This product must
not be disposed of with normal
household waste.
Separate collection of used products
and packaging allows materials to be
recycled and used again. Reuse of