Black & Decker BXPW1400E Mode D'emploi page 10

ENGLISH
MAIN COMPONENTS (Fig. A)
The machine is delivered partially
disassembled in a carton.
1. Lance
2. Gun with safety catch
3. High pressure hose
4. Nozzle
5. Rotating nozzle
6. Adapter
7. Water filter
8. Brackets
9. Detergent kit
10. Nozzle cleaning tool
11. Screws
12. Electric cable with plug
13. Handle
14. Wheels
15. Lever
16. Hose reel
Caution! Safety devices:
• Starter device (21): The starter device
prevents accidental use of the appliance.
Do not tamper with or adjust the safety
valve setting.
• Safety valve and/or pressure limiting
valve: The safety valve is also a pressure
limiting valve. When the gun trigger is
released, the valve opens and the water
recirculates through the pump inlet or is
discharged onto the ground.
• Thermostat valve (where fitted): If the
water temperature exceeds the
temperature set by the manufacturer, the
thermostat valve discharges the hot
water and draws in an amount of cold
water equal to the amount of water
discharged, until the correct temperature
is restored.
• Safety catch (20): Prevents accidental
10
(Original instructions)
spraying of water
• Overload cutout: stops the appliance in
case of overload.
INSTALLATION (Fig. B)
ASSEMBLY
Caution! All installation and assembly
operations must be performed with
the appliance disconnected from the
mains power supply.
The assembly sequence is illustrated in
Fig.B.
Assembling the rotating nozzle
The rotating nozzle kit delivers greater
washing power. Use of the rotating nozzle
may cause of reduction in pressure of 25%
compared to the pressure obtained with the
adjustable nozzle. However, the rotating
nozzle kit delivers greater washing power
due to the rotation of the water jet.
Electrical connection
Caution! Check that the electrical
supply voltage and frequency (V/Hz)
correspond to those on the
appliance data plate (Fig.B8).
The appliance should only be connected to a
mains power supply equipped with an
adequate earth connection and a di erential
security breaker (30mA) to cut o the
electricity supply in the instance of a short
circuit.
Use of extension cables: Use cables
featuring "IPX5" protection level. The
cross-section of the extension cable should
be proportionate to its length; the longer it
is, the greater its cross-section should be.
Water supply connection
Caution! Only clean or filtered water
should be used for intake. The
delivery of the water intake tap
should be equal to that of pump capacity.
Place the appliance as close to the water
supply system as possible.
Connection points:
Water outlet (OUTLET)
Water inlet with filter (INLET)