Black & Decker BXPW1400E Mode D'emploi page 11

Connection to the mains water
supply
The appliance can be connected directly to
the mains drinking water supply only if the
supply hose is fitted with a backflow
preventer valve as per current regulations in
force. Make sure that the hose is at least Ø
13mm and that it is reinforced.
ADJUSTMENT INFORMATION
(Fig. C)
• Adjusting the spray nozzle: Water flow is
adjusted by regulating the nozzle (4).
• Adjusting the detergent: To deliver
detergent at the correct pressure, set the
nozzle (4) (where fitted) on "
the detergent kit (9) as shown.
• Adjusting the pressur: The regulator is
used to adjust the working pressure. The
pressure is shown on the pressure gauge
(where fitted).
USE OF THE APPLIANCE (Fig. D)
CONTROLS
Starter device (21)
Set the starter switch on (ON/I) to:
a) start the motor (in models without TSS
device);
b) set the motor ready to start (in models
with TSS device). If there is a pilot light
on the starter device, it should light up.
Set the starter device switch on (OFF/0)
to stop the appliance. If there is a pilot
light on the starter device, it should go
out.
• Water jet control lever (19).
Warning! - Danger!
During operation the appliance must be
positioned as shown in Fig. D. on a firm,
stable surface.
Start-up (Fig D)
1. Turn on the water supply tap fully.
2. Release the safety catch (20).
(Original instructions)
3. Depress the gun trigger for a few seconds
and start up the appliance using the
starter device (ON/I).
Warning! - Danger!
Before starting up the appliance check that
it is receiving water correctly; use of the
appliance without water will damage it. Do
not cover the ventilation grilles when the
appliance is in use.
TSS models - In TSS models
(with automatic delivery flow cut-o
system):
• when the gun trigger is released the
dynamic pressure automatically cuts out
the motor;
" or fit
• when the gun trigger is depressed the
automatic drop in pressure starts the
motor and the pressure is restored after a
very slight delay;
• if the TSS is to function correctly, all gun
trigger releasing and depressing
operations must be at least 4-5 seconds
apart.
To prevent damage to the appliance, do not
allow it to operate dry and check that it is
properly supplied with water. For models
without TSS, to prevent damage to the
appliance due to an increase in water
temperature, do not cut o
for more than 5 minutes with the appliance
running. Beware of kickback force when
opening the trigger gun.
Stopping the appliance
1. Set the starter device switch on (OFF/0).
2. Depress the gun trigger and discharge
the residual pressure inside the hoses.
3. Engage the gun safety catch (20).
Restarting
1. Release the safety catch (20).
2. Depress the gun trigger and discharge
the residual air inside the hoses.
3. Set the starter device on (ON/I).
ENGLISH
the jet of water
11