HP Photosmart C4340 All-in-One Série Guide D'utilisation page 53

Chapter 4
• The print carriage is not stalled or blocked. Turn off the product, remove any objects that
are blocking the print cartridge carriage (including any packing materials), and then turn on
the product again.
• The print cartridge door is closed. If not, close the print cartridge door, as shown below:
NOTE:
next to OK to clear the message and resume faxing.
After you resolve any problems found, the product can begin answering incoming fax calls.
Cause: An error condition was preventing the product from receiving faxes and Backup Fax
Reception was set to Off.
Fax tones are recorded on my answering machine
Try the following solutions to resolve the issue. Solutions are listed in order, with the most likely
solution first. If the first solution does not solve the problem, continue trying the remaining solutions
until the issue is resolved.
Solution 1: Make sure the answering machine is connected to the correct port
Solution
NOTE:
phone cord in the box with the product, including: Argentina, Australia, Brazil, Canada, Chile,
China, Colombia, Greece, India, Indonesia, Ireland, Japan, Korea, Latin America, Malaysia,
Mexico, Philippines, Poland, Portugal, Russia, Saudi Arabia, Singapore, Spain, Taiwan,
Thailand, USA, Venezuela, and Vietnam.
When you have an answering machine on the same phone line you use for fax calls, you must
connect the answering machine directly to the product using the port labeled 2-EXT, as shown
below.
50 HP Photosmart C4340 All-in-One series
If the product has an alignment message, you might be able to press the button
This possible solution applies only in the countries/regions that receive a 2-wire