X 2 or 3 stages heating
Example: To cook food at HIGH power for 2 minutes and at DEFROST power for 1 minute
PAD
Follow steps 1 to 3 on page 18.
4
Press Power Level Selector pad four times.
The selected power level will be indicated and 2nd Stage Heating
Indicator "2" will start to blink.
5
Set the desired heating time for the second stage using the Timer
Dial.
The set heating time will appear.
Note: up to 15 min. on
6
Press Start pad.
The oven lamp will turn on. The total time for both stages will
appear and start to count down. 1st Stage Heating Indicator "1" and
Power Level Indicator for the first stage heating will start to blink.
• After the first stage heating, a single beep tone will sound. 2nd Heating Stage Indicator
"2" and Power Level Indicator for the second stage heating will start to blink and the
remaining heating time will count down.
• When all time expires, beep tone will sound and heating will stop. The oven lamp will
turn off. "0" will blink until the door is opened. One minute later, cooling fan will stop.
• Open the door and take the food out. The oven lamp will turn on. Digital Display
Window will show the originally set time and power.
• Close the door. The oven lamp will turn off. One minute later, Digital Display Window
will go blank.
Note: For 3 stages Heating, repeat steps 4 and 5 above before pressing Start pad
SPECIAL NOTE: For both single and 2 or 3 stages heating
1. While heating, one press on Stop/Reset pad stops the operation. You can restart it by pressing Start pad or
a second press on Stop/Reset pad will cancel the selected program.
2. While not heating, one press on Stop/Reset pad cancels the selected program.
3. You can repeat exactly the same manually selected heating time by pressing only Start pad
the oven again within one minute (within 30 minutes when the door has been left open).
4. One minute later of non-use with door closed, the repeat feature will be cancelled.
How to Operate NE-1880
INSTRUCTION
or
, 60 min. on
- 19 -
DIGITAL DISPLAY WINDOW
,
or
.
1
1
2
1
2
1
2
2
1
2
, if you use