Hanger Kit - Honda EU70is Manuel De L'utilisateur

HANGER KIT

Protect the fuel tank and frame pipe with the protector films during
installation of the hanger.
1.Slide one end of the hanger under the frame pipe on the left side of
the generator.
2.Slide the other end of the hanger under the frame pipe on the right
side of the generator.
3.Slide the hanger along the frame pipes to align the center of the
hanger with the recessed part on the rear side of the fuel tank.
4.Install the hanger brackets on both ends of the hanger and tighten
the 8×16 mm flange bolts securely.
TORQUE: 24–29 N·m (2.4–3.0 kgf·m, 17–22 lbf·ft)
HANGER
HANGER
OPTIONAL PARTS
PROTECTOR FILM
(commercially available)
8×16 mm FLANGE BOLT (4)
HANGER
BRACKET (2)
89