Putting Into Operation; Transport And Installation - Abicor Binzel XFUME ADVANCED US Mode D'emploi

Système d'extraction des fumées de soudage
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6 Putting into operation

6 Putting into operation
DANGER
Risk of injury due to unexpected start
The following instructions must be adhered to during all maintenance, servicing, assembly, disassembly and repair work:
• Switch off the extraction system.
• Disconnect all electrical connections.
DANGER
Risk of fire
Before installing and operating the extraction system, please observe the following:
• The extraction of welding fumes while welding oily parts is prohibited.
• The system must not be installed in areas that are subject to dust or gas explosion hazards.
• Before putting the system into operation, check whether the operating voltage specified on the nameplate corresponds
to the mains voltage.
• The operating, maintenance and servicing conditions must be observed.
NOTICE
• Only use the extraction system in sufficiently ventilated rooms.
• The extraction system is equipped with a safety device to monitor the minimum air volume flow to be extracted.
Monitoring occurs using a differential pressure switch (ON/OFF). If a filter change is required, the service light (1)
lights up.
 Fig. 5 on page EN-13.
• The extraction system must be positioned on a flat surface near the work area.
• Only qualified personnel are permitted to perform work on the device or system.

6.1 Transport and installation

CAUTION
Risk of injury
Injuries may be caused by improper handling:
• Use an appropriate lifting tool with load securing devices for transport and installation of the device.
• Only transport the device over even ground.
• Watch out for obstacles.
• Avoid lifting and setting down the device abruptly.
• If passing over an edge, ensure that the filter housing is not in position on the system as this can damage the filter
housing.
• Do not lift the components over persons or other devices.
• Check and wear your personal protective equipment.
• Send bystanders out of the danger zone.
• Note the weight of the extraction system when lifting it.
 3.1 Technical data on page EN- 6
CAUTION
Risk of toppling
Physical injury or damage to the extraction system can result from its improper transportation and positioning.
• Place the extraction system on a suitable surface (flat, solid, dry) on which it will not topple over.
EN - 10
xFUME ADVANCED US
BAL.0814.0 • 2020-06-17

Publicité

Table des Matières
loading

Table des Matières