Emergency Information; Putting Into Operation - Abicor Binzel EN 60 974-7 Mode D'emploi

PP

3.2 Emergency information

4 Putting into operation

1
7
1 Types 24/36/240D
2 Contact tip
3 Tip adaptor
Fig. 1 Equipping the torch
NOTE
Describes the risk of impairing work results or the risk that the work may
result in material damage to the equipment.
In case of emergency, immediately interrupt the following supplies:
• Electricity, compressed air
Further measures can be found in the "Power supply" operating instructions or
in the documentation of further peripheral devices.
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power supply and close off the compressed air supply.
• Pull the mains plug.
Equip the torch neck according to one of the following figures:
2
4 Gas diffuser
5 Torch neck
NOTE
• Slide the gas nozzle on the torch neck rotating it slightly clockwise.
4 Putting into operation
3 4
6 Type 401D
7 Gas nozzle
5
6
EN - 5