SilverCrest STKK 16 B1 Mode D'emploi page 19

Mounting the transmitter
NOTE
► You will need a Phillips screwdriver and a drill
with a 5 mm drill bit to mount the transmitter.
Only use the screws t and wall plugs r
►
provided to mount the transmitter.
► Ensure that there are no electric lines, water or
heating pipes installed at the proposed drilling
location!
► The supplied wall plugs r are only suitable for
mounting in concrete or stone. Before starting
the installation, please check your installation
location carefully for its suitability for the wall
plugs r. The assembly material must be suita-
ble for the respective location.
If in doubt, consult a professional.
► Alternatively, you can mount the transmitter
using the double-sided adhesive tape w onto a
suitable surface (maximum height 2 m).
♦ Select a suitable positioning for the transmitter,
close to your outer door.
│
■ 16
GB │ IE
STKK 16 B1