Publicité
Les langues disponibles
Les langues disponibles
"HUSKY 10-16K GLIDER" INSTALLATION
1.
Place driver side assembly & passenger side assembly into base rail slots.
2.
Insert base rail pins from rearward side of base rails and secure with clips.
3.
Lift clevis/yoke located on driver side pivot up as far as it will go.
4. Place Husky pivot plate on recesses on pivot stops by tipping the passenger side assembly
outward to get the plate in place. Slotted tabs on plate should rest in recesses on pivot stops.
Using 1/4" bolts, flat washers and lock washers, thread into holes on pivot stops finger tight only.
Visit
www.huskytow.com
2021 Keystone Automotive Operations Inc. All Rights Reserved. 08/25/2021-Rev10
or 1 (877) 544-4449 for Warranty Information / Tech Support / Product Updates.
SLOTTED TAB &
1/4" HEX BOLT.
Page-5
Publicité
