Publicité
Les langues disponibles
Les langues disponibles
1.
Align trailer and tow vehicle in a straight line on a level surface.
2.
Pull up on link and push in on the handle then release link.
3.
When the handle is put into the driving position, make note whether the pivot stops rotated or
not. If they did then proceed to step 5.
4.
If the pivot stops did not rotate, then you will need to set the trailer brakes and then pull the
tow vehicle forward slightly until you hear the pivot stops actuate. Then proceed to step 5.
5.
Set the trailer brakes and slowly move the tow vehicle rearward until the "HUSKY 10-16K"
stops moving and you hear the pivot stops engage.
View showing pivot stops in the driving "locked" position from inside of the driver side assembly
1.
Every 5,000 miles check all bolted connections to ensure the
proper torque is applied. (See page 1 for proper torque values
based on fastener size and grade.) Also, apply fresh grease to
the pivot shafts to ensure trouble free movement of the pivot
stops.
2.
Using compressed air, clean cloth or hand brush periodically
wipe off the sliding surface of the "HUSKY 10-16K".
3.
Do not use any kind of lubrication on the lower sliding pad as
this may affect sliding performance and accelerate wear.
4.
Before each trip, it is a good idea to check the actuating
mechanisms of the "16K Husky-10" for proper movement and
make any corrections/adjustments if needed.
5.
If system is removed from base rails with the cross member and
pivot plate still installed and then replaced back into the base
rails, no adjustments should be needed. BUT it is a good idea
to check all connections, settings and movement before towing
and adjust as needed.
Visit
www.huskytow.com
2021 Keystone Automotive Operations Inc. All Rights Reserved. 08/25/2021-Rev10
Views showing pull handle and system in driving position.
Maintenance and Care
or 1 (877) 544-4449 for Warranty Information / Tech Support / Product Updates.
To Tow:
Page-13
Publicité
