Abicor Binzel ROBO 241 Mode D'emploi page 41

MIG/MAG ROBO welding torch
11 Disassembly
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance,
servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Close the compressed air supply.
• Switch off the entire welding system.
NOTICE
• Disassembly may only be carried out by qualified personnel (in Germany
see TRBS 1203).
• Please consult the operating instructions for the welding components,
such as the power source, wire feeder, recirculating cooling unit, etc.
• Observe the information provided in the following section:
 8 Putting out of operation on page EN-15.
1 Disconnect the cable assembly from the wire feeder.
2 Remove the parts to be disconnected (changeable body, bracket, CAT
robot mount, torch neck).
11 Disassembly
EN - 21