Disposal - CombiSteel 7455.17 Serie Mode D'emploi

The appliance is not properly
levelled
The discharge outside is blocked
The appliance is
Movement of water to the drain
leaking water
is obstructed
The water container is damaged
The drip tray is over flowing
Loose nut/screw
The appliance is
The appliance has not been
unusually loud
installed in a level or stable position

DISPOSAL

If the appliance is no longer of use and you wish to dispose of it, remove doors to prevent any small child from
be trapped inside. Then please do in an environmentally correct way.
Contact a qualified service technician:

To recover all Freon/refrigerant

To remove the compressor or remove the oil from the compressor

To remove the flammable insulation blowing gases
Then the distributor/ retailer can contact their local metal recycling center to pick up the remaining cabinet,
shelves, etc.
There may be special requirements or conditions. You can obtain information on the disposal of refrigeration
appliances from:

Your supplier

Government authorities (The local council, Ministry of the Environment, etc.)
By law, disposal of hazardous wastes may be subject to fines and imprisonment under the provisions of the
environmental regulations.
1. The refrigerant of this unit is a hydrocarbon refrigerant and is covered by the Kyoto Protocol.
2. Releasing the refrigerant to the atmosphere will harm the environment by contributing to the global
warming. The Global Warming Potential (GWP) of R600a/R290 is 3.
Disposal
Discarded electric appliances are recyclable and should not be discarded in the domestic waste!
Please actively support us in conserving resources and protecting the environment by returning
this appliance to the collection centres (if available).
Dispose of packaging in accordance to applicable legal regulations.
Adjust the screw feet to level the appliance (If
applicable)
Clear the discharge outlet
Clear the floor of the appliance (if applicable)
Call your agent or qualified technician
Empty the drip tray (if applicable)
Check and tighten all nuts and screws
Check installation position and change if necessary
15