Table Des Matières - Cebora ITACA GP73190-BIO Manuel D'instructions

EN - INSTRUCTION MANUAL FOR COOLING UNIT
1 SAFETY PRECAUTIONS ....................................................................................................................................10
1.1 I ..........................................................................................................................................................10
ntroductIon
2 GENERAL DESCRIPTIONS ...............................................................................................................................10
2.1 S ........................................................................................................................................................10
pecIfIcatIonS
2.2 e
xplanatIon of technIcal SpecIfIcatIonS
2.3 d
eScrIptIon of protectIon devIceS
2.3.1 Grade of protection of the electrical system ...........................................................................................................................10
2.3.2 Coolant pressure protection ...................................................................................................................................................10
2.4 d
eScrIptIon of the devIce
3 INSTALLATION AND START UP........................................................................................................................ 11
3.1 c
onnectIng coolIng unIt
3.2 e
lectrIcal connectIon between coolIng unIt
3.3 c
onnectIng the power Source
4 MOTORISED PUMP SPECIFICATIONS PLATE DATA .....................................................................................14
5 MAINTENANCE ..................................................................................................................................................15
IMPORTANT: BEFORE USING THIS DEVICE, READ THIS MANUAL CAREFULLY TO MAKE SURE YOU UNDER-
STAND ITS CONTENTS AND PUT THEM INTO PRACTICE
Copyright
The copyright of these operating instructions is owned by the manufacturer. The text and illustrations
correspond to the technical specifications of the device at the time of printing and are subject to change.
No part of this publication may be reproduced, stored in a filing system or transmitted to third parties in any
form or by any means, without the manufacturer's prior written authorisation. We are always grateful to be
informed of any errors and suggestions for improving the operating instructions.
Always keep this manual at the place where the device is used.
The equipment can only be used for welding or cutting operations. Do not use this device to charge batteries,
defrost pipes or start motors.
Only expert staff can install, operate, maintain and repair this device. An expert staff member means someone
who can judge the work assigned to them and recognise possible risks based on their vocational training,
knowledge and experience.
Any use that differs from what is expressly indicated and is implemented in different ways or contrary to what
is indicated in this publication amounts to improper use. The manufacturer declines any liability arising from
improper use that may cause accidents to people and possible system malfunctions.
This exclusion of liability is acknowledged upon commissioning of the system by the user.
The Manufacturer is unable to monitor compliance with these instructions or device installation, operation and
use, and maintenance conditions and methods.
Inappropriate execution of the installation may lead to material damage and possible personal injury.
Therefore, no liability is assumed for loss, damage or cost arising out of or in any way connected with improper
installation, incorrect operation or inappropriate use and maintenance.
3301128/A
TABLE OF CONTENTS
...................................................................................................................10
...........................................................................................................................10
........................................................................................................................................ 11
I n 1685 tIg
tem o to power Source
I n
tem
,
complete wIth coolIng unIt
I n 559...............................................................12
tem o
1685 tIg
o and power Source
,
to tranSport trolley
I n 559 ...............................13
tem o
I n 1676 ............................... 14
tem o
9