ENGLISH
BEFORE MACHINE START-UP
WARNING!
When starting the machine, or before operating the One Touch button (43), make sure that there is no foreign
material between the deck and the tank assembly which could obstruct the deck movement. If the machine has
been turned off without lifting the deck, the deck would lift automatically at next machine start-up.
Brush or pad-holder removal/installation
According to the kind of cleaning to be performed, the machine
can be equipped either with the brush (A, Fig. 2) or the pad-
holder (B) with pad (C) together with the appropriate deck.
1.
Place the brush (A) or the pad-holder (B) under the deck
(7).
2.
Place the user key (52) in the key reader (41), then press
the push-button (42) to start the machine.
3.
Press the One-Touch button (43) to lower the deck onto the
brush.
4.
Press the switch (45) to engage the brush.
5.
To remove the brush, the deck must be lifted by pressing
the One-Touch push-button (43), then press the release
push-button (45).
When the display shows the icon (51-K), wait for the brush
to fall on the floor.
Available brushes and their relevant application guides (suggestions only)
Models
General cleaning:
Concrete
Terrazzo floor
Ceramic tiles/quarrystones
Marble
Vinyl tiles
Rubber tiles
Polishing:
Rubber tiles
Marble
Vinyl tiles
12
INSTRUCTIONS FOR USE
46 GRIT
80 GRIT
SC2000 - 9100000383
B
C
180 GRIT
240 GRIT
500 GRIT
revised 07/2017
A
Figure 2
PROLENE
PROLITE
UNION MIX
P100864
01/2015