HP 9200c Digital Sender Guide De Mise En Route page 25

a. Click the Find Servers button. The Select LDAP Server dialog box appears,
b. Select the LDAP server that you want to use. The information about the selected
c. Click OK to accept the selected server. The server information is filled in on the
d. Click the Test button to test the settings. In the Test User Authentication dialog
13. Click Next to continue to the Fax Settings screen.
Fax configuration is not included in this procedure. If you are planning to enable sending to
NOTE
fax, see the HP 9200C Digital Sender Support Guide for instructions.
14. Click Next to continue to the Folder Settings screen.
15. If you would like to make the send-to-folder feature available, select the Enable Send to
Folder check box.
a. Click Add... to add a new folder. The Add Predefined Folder dialog box appears.
b. Type a name for the folder into the Alias Name text box. This name appears in the
c. Click Browse... to browse to a folder location, and then click OK to accept it.
NOTE The supported operating systems for folder destinations are Windows 98, Windows NT,
Windows 2000, Windows Server 2003, Windows XP, and Novell NetWare.
d. In the Access Credentials drop-down list, select the credentials that you want to
e. Click OK to save the settings. The new folder is added to the list.
f.
g. In the Credentials to Access Public Folders area of the Folders tab, type the
16. Click Next to continue to the Workflow Settings screen.
Workflow configuration is not included in this procedure. If you are planning to enable
NOTE
sending to workflows, see the HP 9200C Digital Sender Support Guide for instructions.
17. Click Next to continue to the Addressing Settings screen.
ENWW
containing a list of LDAP servers on the network. (You might first be prompted for
your network login information.)
server appears.
Authentication Settings screen.
box, type in the network logon credentials of a network user in order to test whether
LDAP can successfully retrieve an e-mail address. If the test is not successful,
contact your network administrator to troubleshoot the LDAP configuration.
device control-panel interface.
use for access to the folder. If Public is selected, the program uses the Credentials
to Access Public Folders from the Folders Settings screen. If MFP User is
selected, the program uses the credentials with which the user has logged into the
device.
Repeat steps a through e to add more folders.
public access credentials for saving files into folders. This information is required
before you can save the folder list.
Step 9. Install and configure the software 19