HP 9200c Digital Sender Guide De Mise En Route page 16

Step 3. Change the control-panel overlays
The device comes with overlays installed on the control panel, and overlays for different
languages might be included in the box. If necessary, use the following procedure to change
the control-panel overlays to support your preferred language.
1. Locate the two control-panel overlays.
2. Insert a small, flat-blade screwdriver or other thin tool in the slot at the top edge of one of
3. Lift the overlay up and back to remove it from the product.
4. Position the new overlay over the control panel. Align the ends of the overlay with the
10 Chapter 2 Setup
the overlays to pull the top away from the control panel.
holes on the control panel and slide the overlay in.
ENWW