Section 2 - Transport; Packing; Handling And Transport; Control Upon Reception - MAXA OTA micro 15 Manuel Utilisateur

SECTION 2 - TRANSPORT

2.1 Packing

• The regenerators and their accessories are inserted in cardboard boxes that will must remain integral until the moment
of the assembly.
• The components that, due to technical requirements, are not assembled, are supplied packed in a suitable covering
and fixed to the inside or outside of the unit.

2.2 Handling and transport

• For the handling, in function of the weight, use adequate means in conformity to the directive 89/391/EEC and suc-
cessive modifications.
• The weight of every single machine is shown on the attached technical data sheet.
• Avoid rotations without control.
• Take utmost care during loading operations: all the machines must be loaded and stored in the truck interposing
opportune spacers to safeguard all protruding parts like water couplings, handles, hinges.

2.3 Control upon reception

Upon reception of the goods, please carry out a control of all the parts, verifying that the transport has not caused
damages. All damages must be communicated to the carrier, putting a reserve clause on the delivery note and spe-
cifying the type of damage.

2.4 Storage

In case of long term storage, keep the machines protected from dust and from all sources of vibrations and heat.
The MAXA company declines every responsability for damages due to uncorrect unloading or not sufficient
protection against atmospheric agents.

SECTION 3 - INSTALLATION AND START UP

3.1 Definitions

CUSTOMER - The customer is the person, the agency or the company, that has acquired or rented the unit
and that uses it for the conceived purpose.
USER / OPERATOR - The operator or user is the physical person who has been authorised from the customer to
operate with the machine
SPECIALISTIC STAFF - Intended are all those physical persons who have achieved a specific training, are therefore
in a position to recognize the dangers deriving from the use of this machine and are able to avoid them.

3.2 Emergency norms

The MAXA Company declines any responsability for the non observance of the emergency and prevention norms
described below.
It declines furthermore responsibility for damages caused by an improper use of the unit and/or by modifications car-
ried out without authorization.
• The installation must be carried out by expert and qualified staff.
• During installation operations, use suitable accident-prevention clothing, as an example: glasses, gloves, etc as indi-
cated by the 686/89/EEC and successive norms.
• During installation, operate in absolute safety, in clean surrounding and free from impediments.
• Respect the laws in force in the Country in which the unit is installed, concerning the use and the disposal of the pac-
kings and the products used for cleaning and maintainig the machine and follow the manufacturer instructions of such
products.
• Before putting the unit in function, check the perfect integrity and safety of all components and of the entire system.
• Avoid touching the parts in motion or intefering with the same ones.
• Switch off the electric power supply before proceeding with cleaning or maintenance operations.
• The maintenance and the substitution of damaged or worn out parts of the unit must be carried out by qualified staff
only and following the indications contained in this handbook.
21
.
OTA micro 15÷50