Quickie Freestyle M11 Mode D'emploi Et Garantie page 28

28
5. Operation
The remote joystick connects to a controller, which controls the chair's performance. The
joystick assembly consists of the following parts:
Speed Control Knob (D)
Use the speed control knob to adjust the maximum speed of your chair. Turn it counter-
clockwise to reduce speed; turn it clockwise to increase speed.
Battery Charge Indicator (B)
• Green lights indicate that batteries are fully charged.
• Yellow lights indicate that batteries need recharging.
• When the lights stay in the red band, the batteries must be recharged.
On/Off Mode Switch (A)
The on/off mode switch is located on the rear face of the joystick housing. It is a toggle
switch. Turning the chair on or off, is accomplished by pressing the switch downward. The
switch will automatically return to the center point. Alternate locations exist for this switch.
Please see your supplier in the event that you wish to relocate or re-orient this switch.
Mode Switch (A)
The on/off mode switch allows you to select from 5 (five) different programmable drive
profiles or actuator mode sets.
• Push up the on/off mode select toggle switch to index among the five drive and
actuator modes. The selected mode indicator will flash.
• Push joystick either left or right to select one of the five drive profiles. To select the
actuator modes, push up on the mode select switch twice.
• The drive profiles are indicated by the mode indicators (G), and the actuators are
indicated by the four actuator lights (H).
• To exit drive or actuator mode select, simply push the on/off/mode toggle up one or
more times until the indicator no longer flashes, or push the joystick forward or
reverse to begin driving.
Joystick (E)
The joystick controls the direction and speed of your chair. Turn the chair on and move the
joystick in the direction you want to go.
• Moving the joystick from the neutral (center) position disengages the motor locks,
allowing the chair to move.
• The chair will move faster the more you move the joystick away from neutral.
NOTE– If your speed becomes hard to manage, release the joystick, and the chair will come to a com-
plete stop.
• When you release the joystick it will return to neutral; the chair will slow to a stop
and the motor locks will reengage.
• We recommend that you switch the chair off if you stop for any length of time. This
will conserve battery power.
NOTE– Once the chair stops, switching the chair off will not affect the motor locks.
Joystick Boot (F)
Make sure the boot is not torn or cracked (this could allow debris, water or moisture to
enter). If the boot is torn or cracked, replace it as soon as you can.
Remote Switch Jacks (optional– not shown)
Two 1/8" switch jacks are optional to provide remote switch control of the on/off power
function and the mode select function. Any of the single switches offered by Sunrise
Medical can be used to connect to either or both of these jacks (except the single zero
touch switch).
1. Never use the ON/OFF switch to stop your chair except in an emergency.
This will result in an abrupt stop and may cause you to fall.
2. To slow or stop your chair, return the joystick to neutral.
930583 Rev. F
E n g l i s h
X . O p e r a t i n g G u i d e
E
F
B
D
A
Remote Joystick (optional)