Publicité
Les langues disponibles
Les langues disponibles
8619470
6.
Turn the power source on and select the MIG function with the welding mode knob. An
alternative is to use the Smart-Set option (see Smart-Set) (Fig. 7-6).
7.
Set torch operation 2T / 4T (Fig. 7-5).
•
2T - Press and hold the trigger to start the arc. Release the trigger to stop.
•
4T - Press and release the trigger to start the arc. Press and release the trigger to stop
the arc.
The burnback function is automatic and preset for both selections.
8.
Set the welding parameters using the wire feed (D) and voltage control knobs (E). These
will already be set if Smart-Set was selected (Fig. 7-7).
INSTALLATION & OPERATION FOR GASLESS MIG
1.
Connect the MIG Torch to the Euro connector (H) and tighten the connector.
2.
Connect the ground lead to the positive output socket (I) (Fig. 7-3).
3.
Connect the dinse connector to the negative outlet socket (G) (Fig. 7-2).
4. Install flux-cored welding wire and the knurled drive roller (see Wire Installation and Setup).
5.
Turn the power source on and select the MIG function with the welding mode knob.
6.
Set torch operation 2T / 4T.
•
2T - Press and hold the trigger to start the arc. Release the trigger to stop.
•
4T - Press and release the trigger to start the arc. Press and release the trigger to stop
the arc.
The burnback function is automatic and preset for both selections.
7.
Set the welding parameters using the wire feed (D) and voltage control knobs (E). These
will already be set if Smart-Set was selected.
INSTALLATION AND SET UP FOR DC TIG WELDING
The set up described is for DC Electrode Positive (DCEP).
1.
Connect the TIG torch to the Euro connection socket and tighten the connection (Fig. 8-4).
2.
Connect ground lead to the negative outlet
socket (Fig. 8-3).
3.
Connect the dinse connector (J) to positive
output socket (G) (Fig. 8-5).
4. Turn the power source on and select the
TIG function with the welding mode knob
(Fig. 8-7).
5.
Set torch operation to 2T or 4T (Fig. 8-6).
•
2T - Press and hold the trigger to start
the gas and arc. Release the trigger to
stop.
•
4T - Press and release the trigger to
start the gas and arc. Press and release
the trigger to stop the gas and arc.
6.
Connect the gas hose to the regulator then
connect the regulator to the gas cylinder (Fig. 8-1). Connect the other end of the gas hose
(Fig. 8-2) to the gas inlet (L) on the rear of the welding machine. Check for gas leaks.
14
145A MULTI-PROCESS MIG-ARC-TIG WELDER
8-1
8-2
8-3
8-4
8-5
For technical questions call 1-800-665-8685
V1.0
8-6
8-7
Fig. 8
Publicité
