Publicité
Les langues disponibles
Les langues disponibles
8619470
11.1 In the event of a power failure, turn off the machine as soon as the power is interrupted.
The possibility of accidental injury could occur, if the power returns and the unit is not
switched off.
12. Make certain the power source conforms to requirements of your equipment
(see Specifications).
POWER TOOL PRECAUTIONS
This equipment requires a dedicated 115/230 volt, 30 amp single-phase alternating current
circuit equipped with a similarly rated circuit breaker or slow blow fuse. Do not run other
appliances, lights, tools or equipment on the circuit while operating this welding unit.
1.
Do not drape or carry coiled welding cables on your body while the cables are plugged into
the welding unit.
2.
Do not start the tool when the electrode is touching the workpiece.
3.
Hold the tool by the insulated gripping surfaces when performing an operation where it
may contact hidden wiring or its own cord and cables. Contact with a 'live' wire will
electrify exposed metal parts and shock the operator.
4. Take work breaks to prevent the tool's motor from overheating and/or overloading. Refer to
the welding unit's duty cycle in Specifications.
5.
Keep hands away from the electrode and the area it is being applied to when the tool is in
operation.
6.
Do not connect the welding unit ground clamp to an electrical conduit. Do not weld on an
electrical conduit.
7.
Do not touch the electrode or welded surface immediately after use. The surface will be hot
and may cause an injury.
8.
Never use a tool with a cracked or worn electrode. Change the electrode before using and
discard the damaged one.
9.
Remove the electrode from the holder when not in use.
POWER CORD
1.
Insert the power cord plug directly to the power supply whenever possible. Extension cords
are not recommended for use with this welding unit.
1.1 When an extension cord is required, use a welding version that exceeds the welding
unit's maximum power requirement.
2.
Do not operate this tool if the power cord is frayed or damaged, as an electric shock or
surge may occur, resulting in personal injury or property damage.
2.1 Inspect the tool's power cord for cracks, fraying or other faults in the insulation or plug
before each use.
2.2 Discontinue use if a power cord feels more than comfortably warm while operating the
tool.
3.
Keep all connections dry and off the ground to reduce the risk of electric shock. Do not
touch plug with wet hands.
4. Prevent damage to the power cord by observing the following:
4.1 Do not pull on the cord to disconnect the plug from an outlet.
4.2 Keep cord away from heat, oil, sharp edges or moving parts.
4.3 Place the electrical cord in a position that prevents it from contacting the tool or workpiece.
The cord should always stay behind the tool.
10
145A MULTI-PROCESS MIG-ARC-TIG WELDER
For technical questions call 1-800-665-8685
V1.0
Publicité
