Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level; Filling The Magazine Shaft; Setting The Impact Force - Parkside PAT 20-Li A1 Traduction Des Instructions D'origine

Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦ Allow the battery pack
the appliance.
Removing the battery pack:
♦ Press the release button
battery pack .

Checking the battery charge level

♦ Press the battery charge level button
check the status of the battery (see also main
diagram).
The status will be shown on the battery display
LED as follows:
♦ RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Filling the magazine shaft

Remove the battery before carrying out any
work on the power tool (e.g. maintenance,
changing tools, etc.) as well as during the trans-
port and storage of the power tool.
Unintentional activation of the trigger can result in
injury.
♦ Remove the battery pack
♦ Turn the appliance around.
♦ Press the release
♦ Pull the magazine slider
(see fig. B).
♦ Fill the magazine shaft
(see fig. C).
NOTE
► Ensure the correct position for the nails
(see main diagram, face plate
appliance).
♦ After filling, push the release
zine shaft as far as the stop until it clicks into
place.
PAT 20-Li A1
to click into place in
and remove the
to
from the appliance.
together (see fig. B).
backwards
with staples or nails
on the
into the maga-
NOTE
► The fill level indicator
magazine contains staples.

Setting the impact force

NOTE
► Select the lowest impact force sufficient for
stapling. Take into account the length of the
staples or nails you are using as well as hard-
ness of the material you are working with.
Increasing the impact force:
♦ Turn the impact force control
Reducing the impact force:
♦ Turn the impact force control

Operation

Switch on

♦ Press the tacker nose
the material that you want to staple until it is
pushed in a few millimetres.
♦ Press the trigger

Switching on the LED work light

♦ Press the button for the LED work light
minate your workspace in unfavourable lighting
conditions.
shows whether the
clockwise.
anticlockwise.
onto the location on
.
GB │ IE │
to illu-
19 ■