Tronic TLG 1000 D6 Mode D'emploi page 24

Handling and operation
In this chapter you will receive important information for the handling and opera-
tion of the device .
Charging batteries
♦ Place the device on a smooth, level and slip resistant surface .
♦ Compare the technical details with those of your power supplier . If they
match, insert the plug into a mains power socket . The LEDs light up in red
three times . The battery charger is now ready for use .
♦ Insert the batteries into the charging slots . Press the 9 V Block batteries
into the charging slot until they audibly engage .
NOTICE
► 1 to 8 batteries can be individually charged:
- 4 x Type C or Type D batteries in the charging slots 1 to 4, with additionally
2 x Type 9 Volt Block batteries in the charging slots 5 and 6
or
- 6 x Type AA or AAA in the charging slots 1 to 4 and additionally
2 x Type 9 Volt Block batteries in the charging slots 5 and 6 .
♦ The charging process now begins . The battery charger has an LED for each
compartment in the charging slot . The LEDs of the respective charging slots
show the charge status of the individual batteries . In addition, the current
charge status of each battery is shown as a percentage on the display
NOTICE
► If the LED on the charging slot blinks red for longer than 5 seconds, the
battery is either improperly inserted into the loading slot or it is defective .
TLG 1000 D6
.
4
GB │ IE │ ■
21