Télécharger Imprimer la page

Skil 0713 Notice Originale page 11

Masquer les pouces Voir aussi pour 0713:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
Lawn mower
INTRODUCTION
This tool is intended for domestic lawn mowing only
This tool is not intended for professional use
Check whether the packaging contains all parts as
illustrated in drawing 2
When parts are missing or damaged, please contact your
dealer
Assembly instructions 2
- the sequence of the numbers appearing in the drawing
corresponds with the sequence of the steps to be
followed for assembling the lawn mower
! firmly tighten all screws and nuts
Read this instruction manual carefully before use and
save it for future reference 4
TECHNICAL DATA 1
TOOL ELEMENTS 3
A
Cord restraint
B
Cord clip
C
Safety switch
D
Trigger switch
E
Securing wing nut
F
Ventilation slots
G
Grass box
H
Transport handle
J
Rear guard
SAFETY
GENERAL
Avoid operating the mower on wet lawns
The user is responsible for accidents or hazards
occurring to other people or their property
Never operate the tool with a defective rear guard or
defective grass box
When operating the tool without grass box, ensure
that the rear guard is in closed position (risk of injury
caused by rotating cutting blade)
Always switch off tool, disconnect plug from power
source, and ensure that all moving parts have come to a
complete standstill
- whenever leaving the tool unattended
- before clearing jammed material
- before checking, cleaning or working on the tool
- after striking a foreign object
- whenever the tool starts vibrating abnormally
ELECTRICAL SAFETY
Inspect the cord periodically and have it replaced by a
qualified person, if damaged
When operating the tool use a residual current device
(RCD) with a triggering current of 30 mA maximum
Use completely unrolled and safe extension cords with a
capacity of 16 Amps (U.K. 13 Amps)
Only use extension cords with a maximum length of 40
metres (1,0 mm²), 60 metres (1,5 mm²) or 100 metres
(2,5 mm²)
Only use an extension cord of types H05VV-F or
H05RN-F which is intended for outdoor use and
equipped with a watertight plug and coupling-socket
Do not run over, crush or pull the (extension) cord
Protect the (extension) cord from heat, oil and sharp
0713
edges
Inspect the extension cord periodically and replace it,
if damaged (inadequate extension cords can be
dangerous)
PERSONAL SAFETY
• This tool can be used by
children aged 8 and above
and by persons who have
physical, sensory or mental
limitations or a lack of
experience or knowledge if a
person responsible for their
safety supervises them or has
instructed them in the safe
operation of the tool and they
understand the associated
dangers (otherwise, there is a
danger of operating errors and
injuries)
• Supervise children (this will
ensure that children do not play
with the tool)
• Cleaning and user
maintenance of the tool shall
not be made by children
without supervision
Do not operate the tool when barefoot or wearing open
sandals; always wear sturdy shoes and long trousers
Be familiar with the controls and the proper use of the
tool
Never mow in the direct vicinity of persons (especially
children) and animals
Always keep hands and feet away from rotating
parts
Keep away from the discharge opening at all times
Switch on the motor according to instructions and with
feet well away from the cutting blade
Operate the mower at a walking pace only (do not run)
Keep proper footing on slopes and do not mow extremely
steep slopes
Be extremely careful when moving backwards or pulling
the mower towards you
BEFORE USE
Check the functioning of the tool before each use and,
in case of a defect, have it repaired immediately by a
qualified person; never open the tool yourself
Thoroughly inspect the area where the mower is to be
used and remove all hard objects which could be caught
up and thrown by the cutting mechanism
Always ensure that the cutting mechanism is in good
working order (have worn or damaged parts replaced)
Keep all nuts, bolts and screws tight to be sure that the
mower is in safe working condition
11

Publicité

loading

Ce manuel est également adapté pour:

0713 aaF0150713 serie