Precision TA500 Manuel D'utilisation page 9

6. Insert a 3/4" Axle Bushing into the End Plate and place the Bushing and End Plate onto the Axle. Insert a 5/16" x
3/4" Hex Head Bolt into one of the end holes in the Base Plate. Then insert the bolt into the holes in the End Plate,
place a 5/16" Lock Washer onto the bolt, loosely attach a 5/16" Hex Head Nut onto the bolt at this time. Repeat this
process on the other side. Now alternating back and forth between the two bolts tighten the nuts. This will slowly
increase the tension on the Axle Spring, until this side is tight and properly aligned.
5/16" Hex Head Nut
5/16" Hex Head Nut
End Plate
End Plate
3/4" Axle Bushing
3/4" Axle Bushing
Axle
Axle
5/16" x 3/4" Hex
5/16" x 3/4" Hex
Head Bolt
Head Bolt
5/16" Lock Washer
5/16" Lock Washer
Figure 6 Figure 6
9