Precision TA500 Manuel D'utilisation page 11

8. Align the two holes of the Tow Bar and Handle Brace as shown. Insert a 5/16" x 1" Hex Head Bolt into one of the
holes in the Handle BRACE and then through the corresponding hole in the Tow Bar, place a 5/16" Flat Washer onto
the bolt, and secure with a 5/16" Nylock Nut. Repeat process on the next hole. Insert a 5/16" x 3/4" Hex Head Bolt
into one of the two smaller holes on the Clevis Plate and then into the corresponding hole in the Tow Bar, place a
5/16" Lock Washer onto the bolt and secure with a 5/16" Hex Head Nut. Repeat process on the next hole. Insert the
Clevis Pin through the larger front hole of the Clevis Plate and through the hole in the Tow Bar and secure with the
Hitch Pin Clip. Screw the 5/16" Nylock Jam Nut onto the 5/16" x 1-1/4 Hex Head Bolt, leaving enough room for the
Lever Link to fit between the head and the nut. Insert the bolt into the hole in the side of the Tow Bar and secure
with a 5/16" Nylock Nut. See Figure 8.
Figure 6
Figure 6
5/16" x 1" Hex Head Bolt
5/16" x 1" Hex Head Bolt
Handle Brace
Handle Brace
5/16" Flat Washer
5/16" Flat Washer
5/16" Nylock Nut
5/16" Nylock Nut
5/16" Hex Head Nut
5/16" Hex Head Nut
Hitch Pin Clip
Hitch Pin Clip
11
5/16" x 3/4" Hex Head
5/16" x 3/4" Hex Head
Bolt
Bolt
Clevis Plate
Clevis Plate
Clevis
Clevis
Pin Pin
Tow Bar
Tow Bar
5/16" Lock
5/16" Lock
Washer Washer