Precision TA500 Manuel D'utilisation page 12

7. Place a 1/2" Flat Washer onto the 1/2" x 1-3/4" Shoulder Bolt, followed by the Compression Spring, insert it into
the 1/2" hole in the Center of the Lever Link and into the Handle Brace, a 3/8" Flat Washer and secure with a 3/8"
Nylock Jam Nut. Place a 1/2" Nylon Washer onto the threaded stud on the bottom of the Leverage Bar, followed by
the Linkage Bar, secure with a 1/2" Nylock Nut (When nut is snug, back-off one half turn) . Insert the 1/2" x1-1/2" Hex
Head Bolt into the other end of the Linkage Bar, followed by a 1/2" Nylon Washer, then into the hole in the Axle Link
and secure with a 1/2" Nylock Nut. Place the Handle Grip onto the Handle. Put the 5/16" Nylock Jam Nut onto the
5/16" x 2-1/4" Hex Head Bolt leaving about 1/2" Space between the Head of the bolt and the top of the nut. Insert
the bolt into the second hole from the top on the Linkage Bar, then into the corresponding hole of the Handle and
secure with a 5/16" Nylock Nut. Insert a 5/16" x 1-3/4" Hex Head Bolt into the top hole of the Linkage Bar, through
the corresponding hole in the Handle and secure with a 5/16" Nylock Nut. See Figure 7.
5/16" x 1-3/4"
5/16" x 1-3/4"
Hex Head Bolt Hex Head Bolt
5/16" Nylock 5/16" Nylock
Nut
Nut
1/2" x 1-3/4"
1/2" x 1-3/4"
Shoulder Bolt
Shoulder Bolt
1/2" Nylon Washer
1/2" Nylon Washer
Linkage Bar
Linkage Bar
1/2" Nylock Nut
1/2" Nylock Nut
Figure 7
Figure 7
Handle
Handle
Handle Grip
Handle Grip
Compression Spring
Compression Spring
Lever Link
Lever Link
Handle Brace
Handle Brace
Axle
Axle
12
5/16" x 2-1/4"
5/16" x 2-1/4"
Hex Head Bolt
Hex Head Bolt
5/16" Nylock
5/16" Nylock
Nut Nut
5/16" Nylock
5/16" Nylock
Jam Nut Jam Nut
3/8" Nylock Jam Nut
3/8" Nylock Jam Nut
3/8" Flat Washer
3/8" Flat Washer
1/2" x 1-1/2" Hex Head Bolt
1/2" x 1-1/2" Hex Head Bolt
Tow Bar
Tow Bar