Precision TA500 Manuel D'utilisation page 10

7. Align the hole of the Wheel Bracket with the hole in the Axle. Insert a 5/16" x 1-1/2" Hex Head Bolt into the hole
in the Wheel Bracket and Axle. Secure with a 5/16" Nylock Nut. Repeat process on the other side. Place a 1/2" Flat
Washer onto a 1/2" x 3" Hex Head Bolt, followed by a Wheel and then another 1/2" Flat Washer and secure with a
1/2" Nylock Nut (Do not over tighten or the Wheel will not turn). Insert this assembly into the hole in the Wheel
Bracket, them place a 1/2" Lock Washer onto the bolt and secure with a 1/2" Jam Nut. Repeat the process on the
other side. See Figure 7.
1/2" Flat Washer
1/2" Flat Washer
Figure 7
Figure 7
1/2" x 3" Hex
1/2" x 3" Hex
Head Bolt
Head Bolt
Wheel
Wheel
1/2" Nylock Nut
1/2" Nylock Nut
1/2" Lock Washer
1/2" Lock Washer
5/16" Nylock Nut 5/16" Nylock Nut
1/2" Jam Nut
1/2" Jam Nut
10
Wheel Bracket
Wheel Bracket
5/16" x 1-1/2"
5/16" x 1-1/2"
Hex Head Bolt
Hex Head Bolt
Axle
Axle