BH CORE Manuel page 23

EN
USER MANUAL
4. DISPLAY PANEL - ROAD & GRAVEL
4.1 Overview of the Display Panel
Central Display Panel with a screen located in the centre of the handlebar, with a remote control located on the
left side of the handlebar:
1. POWER button.
2. Pedal assistance mode indicator colour.
3. Battery level indicator.
2 3
1
Mando Remoto
The range is calculated based on the riding conditions during the last
NOTE
kilometre and the remaining capacity of the battery.
4.2 Display Panel Operation
4.2.1. Switching the Pedal Assistance System On and Off
The pedal assistance system is turned on by holding down the POWER
button for 1 second. The pedal assistance system is turned off by holding
down the POWER button again for 1 second.
The bicycle can be used normally without any type of assistance.
After turning the system on, make sure that you do not start riding without
checking the assistance mode. By default, it starts with the assistance mode
WARNING
selected before it was last switched off.
Wait for 3 seconds after turning on the system before you start applying
pressure on the pedals. During this 3-second period, the assistance system is
starting up and calibrating the torque sensor. Otherwise, if you press the pedal
NOTE
beforehand, this may weaken assistance and error 14 may even be displayed
on the screen (see Troubleshooting section). To fix this, you should reboot the
system without applying pressure on the pedals for a period of 3 seconds.
44
CORE CORE
4.2.2 Pedal Assistance Mode Selection
The system has 5 pedal assistance modes:
BOOST
SPORT
ECO +
ECO
NO ASSIST
To toggle through the assistance modes, the user must press the POWER button to increase the level of
assistance. To reduce the level of assistance, you should quickly press the POWER button twice.
1 sec
Identified by the Red Colour. Use when you want to get maximum power from the
system.
Identified by the Orange Colour. Use when climbing difficult terrains.
Identified by the Blue Colour. Use when you want a more comfortable ride, e.g.
when climbing a steep hill.
Identified by the Green Colour. Use when you want to travel as far as possible.
Identified by the Gray Colour. Use when you want to travel without assisted power.
You can continue to use the other functions of the display panel.
Instant Power Options
1 click
2 clicks
During a journey, selecting suitable assistance modes for the terrain and
NOTE
pedalling conditions that you encounter will ensure the best balance between
battery economy and pedalling comfort.
EN
USER MANUAL
45