Motor; Warranty Programme; Warranty - BH CORE Manuel

EN
USER MANUAL
6.6.2 Functioning as a conventional bottle holder
The bottle holder has a connector that is designed to be water-resistant, thus ensuring that the system is protected.
So the user can place a normal bottle of water in the bottle holder or leave it empty.
6.6.3 Charging and discharging the XPro battery
The Xpro battery can be charged directly or while it is installed in the bike. In the latter case, the charger will initially
charge the bike's internal battery and, when this is completed, it will start charging the Xpro battery.
To start charging the XPro battery installed in the bike, the user must make
sure that the battery is not in deep sleep mode. To do this, press the bike's
WARNING
On button, activating the XPro battery.
6.6.4 XPro battery discharge
In order to increase the life of the XPro battery and the internal battery and prevent an incomplete discharge that
could damage them, the assistance modes are limited depending on the charge of both batteries.
TOTAL CHARGE LEVEL BATTERY IN USE
48%-133% Internal
25%-48% XPro
18%-25% XPro
6%-8% Internal
1%-6% Internal
In the change of use from one battery to another (internal to XPro or XPro to
internal), it is normal for motor assistance to cut off for 2-3 seconds.
WARNING
6.6.5 Information about the battery on the displays
When the XPro battery is installed in the bike, the battery's capacity will be added to the capacity of the bike's
internal battery and the display will show the total charge level of both as follows:
• On the Core Display, if both batteries are charged, the excess capacity of both batteries combined
over the internal battery's nominal capacity will be shown by the LEDs flashing, showing the additional
charge.
60
CORE
ASSISTANCE
Up to 100% available
Up to 100% available
Up to 50% available
Up to 25% available
Only lights available
CORE
CORE DISPLAY
When the XPro battery is displayed, the main display will change to show the additional capacity of the XPro
battery. On the display with 12 LEDs, up to 4 LEDs will flash to show the additional capacity of the XPro battery
(180 Wh)..
Flashing LEDs
12+4 LEDS
720WH
• On the X Display, if both batteries are charged, the excess capacity of both batteries combined over the
internal battery's nominal capacity will be shown by the battery bar being blue with a % above 100% being
displayed.
X DISPLAY
The battery icon will show the XPro battery's additional capacity.
18 18
! !
20 55
% %
8
% %
160 160
RNG RNG
TRIP TRIP
km km
60 % User 60 % User
0% - 24% 25% - 74%
(0-134WH) (135-404WH)

7. MOTOR

The motor meets the strictest quality requirements, as demonstrated by years of reliability. It is a direct current
motor that is built into the wheel hub, capable of producing power of 200 W and with energy efficiency shown
to be higher than 80%. It is a highly compact and lightweight unit.
As with any other part of your bicycle, the service life of the motor depends on how it is used. Under normal
conditions, the motor can last for 10 to 20 years, or up to 100,000 km.

8. WARRANTY PROGRAMME

8.1 Warranty

A) Under normal conditions of use and with adequate storage and maintenance, BH offers a 2 year warranty
against defects in material and workmanship, for the entire bicycle and its electrical components.
B) For batteries, the warranty is valid for 2 years from delivery date.
C) This warranty only applies to the original owner, and in no case and under any circumstances are the rights
granted by the Warranty Programme transferable.
D) View the Warranty Terms and Conditions on the warranty card that is supplied separately with your BH bike.
USER MANUAL
12+2 LEDS
6 LEDS
630WH
270WH
18 18
! !
99 130
% %
8 8
% %
160 160
RNG RNG
TRIP TRIP
km km
60 % User 60 % User
75% - 100%
101% - 133%
(405-540WH) (541-720WH)
EN
61