Dräger X-am 8000 Mode D'emploi page 36

en Safety-related information
1 Safety-related information
These instructions for use may be downloaded in
other languages from the Technical Documentation
Service database (www.draeger.com/ifu) in electronic
form, or ordered as a free printed copy (order no.
90 33 656) from Dräger.
The technical manual (order no. 90 33 665) can be
downloaded in selected languages in the database for
technical documentation ( www.draeger.com/ifu ) in
electronic form.
1.1 Information on safety notes and
warnings
Safety notes and warnings warn of dangers and provide
instructions for the safe use of the product. Failure to
observe these safety notes and warnings may result in
personal injury or damage to property.
1.1.1 Safety notes
This document contains sections with safety notes
which warn of dangers. The type of danger and the
consequences following failure to observe the safety
note are included in every safety note.
1.1.2 Warnings
Warnings refer to steps of a task and warn of dangers
which may result while the steps are executed.
Warnings appear before the steps.
1.2 Basic safety information
– Before using this product, carefully read these
instructions for use and those of the associated
products.
– Strictly follow the instructions for use. The user must
fully understand and strictly observe the instructions.
Use the product only for the purposes specified in
the Intended use section of this document.
– Do not dispose of the instructions for use. Ensure
that they are retained and appropriately used by the
product user.
– Only trained and competent users are permitted to
use this product.
– Comply with all local and national rules and
regulations associated with this product (e.g.
IEC 60079-14, EN 60079-29-2, EN 45544-2).
– Only specialist, trained personnel are permitted to
check, repair and maintain the product as described
in these instructions for use and the technical
manual. Further maintenance work that is not
detailed in these instructions for use or in the
technical manual must only be carried out by Dräger
or personnel qualified by Dräger. Dräger
recommend a Dräger service contract for all
maintenance activities.
– Only use genuine Dräger spare parts and
accessories when performing maintenance work, or
the proper functioning of the product may be
impaired.
– Do not use a faulty or incomplete product. Do not
modify the product.
– Notify Dräger in the event of any component fault or
failure.
– Substitution of components may impair the intrinsic
safety of the product.
– Electrical pairing with devices which are not listed in
these instructions for use should only be done
following consultation with the respective
manufacturers or an expert.
1.3 Use in areas subject to
explosion hazards
To reduce the risk of ignition of a flammable or
explosive atmosphere, strictly observe the following
warnings:
Use in areas subject to explosion hazards
Devices or components for use in explosion-hazard
areas which have been tested and approved according
to national, European or international explosion
protection regulations may only be used under the
conditions specified in the approval and with
consideration of the relevant legal regulations. The
devices or components may not be modified in any
manner. The use of faulty or incomplete parts is
forbidden. The appropriate regulations must be
observed at all times when carrying out repairs on
these devices or components.
®
X-am 8000